User manual MICROTEK ARTIXSCAN 1100

[. . . ] ArtixScan 1100 Hardware User's Guide English English Copyright © 1999 Microtek Lab, Inc. All rights reserved. First Edition: August 1999 I49-002765A Microtek Lab, Inc. 3715 Doolittle Drive, Redondo Beach, CA 90278-1226 Sales: 800-654-4160 Internet: http://www. microtekusa. com Tech Support Web Page: http://www. support. microtek. com Microtek International, Inc. 6, Industry East Road 3 Science Based Industrial Park Hsinchu 30077, Taiwan, R. O. C. [. . . ] Click Start, Settings, and select Control Panel. Double-click on the System icon in Control Panel and select Device Manager from the top. 10. Double-click on "SCSI controllers" to check whether conflict happens. If a conflict exists, follow the steps in Resolving Situation B. When the settings are all correct, click OK to save the modifications. The dialog box should now show the correct Interrupt Request, Memory Range, and Input/ Output address settings. If you are asked to shut down your computer, select No, then click Close. You will be asked whether you wish to restart your computer. Click Yes and restart your computer. ArtixScan 1100 Hardware User's Guide 15 English English 5 Installation under Windows NT 4. 0 1. Installing the interface card See page 10 for details. Card installation on Windows NT 4. 0 is the same as that under Windows 98 / 95. 6. Troubleshooting After installing the interface card in your computer and connecting the scanner, you may find yourself unable to use the scanner. This is usually due to any of the situations described below: Situation A Your interface card is not properly seated 2. Installing the Windows NT driver a) Start your computer, and log in as Administrator. Note: You must be logged in as Administrator in order to install the scanner software components and use the scanner. In Windows, go to Start, Settings, then double-click on Control Panel, and doubleclick on the SCSI Adapters icon. Select the Drivers tab in the SCSI Controllers dialog box, and click on the Add button. From the list of drivers that appear, select Adaptec for manufacturers on the left, and Adaptec AIC-78xx PCI SCSI Controller on the right. You may be asked to insert your Windows NT CD-ROM at this point; do so. You will be asked to restart your computer. Click Yes to do so. in the PCI card slot on your computer. Situation B The driver for the interface card is not b) properly installed on your computer. Resolving situation A Power down your computer, remove the interface card from your computer. [. . . ] Target type: This option lets you select the Target Description File (TDF) that matches your Q-60E3 calibration target being used for calibration. Note: The Target Description File (TDF) contains colorimetric measurements of the target. Each target lot contains unique colorimetric data, and the Scanner ICC Profiler evaluates the scanned RGB data of the target and then matches it to the colorimetric data inside the TDF to create an ICC color profile -- a characterization of how your scanner "sees" color. 7. 8. 3. ArtixScan 1100 Hardware User's Guide 33 English English System Menu: The System Menu displays current scanner information, lets you view the SCSI chain status, and lets you view the About dialog box of the Scanner ICC Profiler program. 1. Get Current Scanner Info: This command provides information on the current scanner. [. . . ]