User manual MICROTEK GNC I 1000XL 3867A

[. . . ] I49-003867 A 4 5 6 3 1 1 2 3 4 5 6 0 1 1 2 2 4 5 5 6 3 3 35mm Slide Template (3) TMA 1000XL 120 Film Template with Black Plate (3) Connect Scanner To the power adapter A. Remove the yellow "Step 4" sticker from your scanner. Connect the power cord to the back of the scanner. 3. Plug the connector of the TMA 1000XL into the scanner's 15-pin accessory port. NOTE: If you need to transport your TMA 1000XL, you will have to lock it back. [. . . ] Position the photo face down on the upper glass bed, towards the front of the scanner. Center the top along the U-shaped ruler on the scanner. · If asked to calibrate your scanner, you can skip this section for now and come back to it later. Or, if you wish to perform calibration, see the ScanMaker 1000XL User Guide for more details. · If prompted to set up Color Matching, click OK for now to accept the settings. You can always change the settings at a later time. For more details, see the ScanMaker 1000XL User Guide. In the Preview window of ScanWizard Pro, choose Reflective from the Scan Material menu. Click the Overview button in the Preview window to see a preliminary scan of the image. Select the Scan Frame tool, and choose the area to be scanned by sizing the marquee around the targeted area. Specify your scanning requirements in the Settings window. Choose the desired image type and resolution, and adjust the scan frame settings if necessary. Adjust image quality if necessary, using the Advanced Image Correction tools. Click the Scan button in the Preview window to start scanning. (The Scan button appears as the "Batch" button when ScanWizard Pro is launched in stand-alone mode in Windows XP . ) Do You Need Assistance? Manuals If you have additional questions and need further instruction or information, we provide PDF manuals for: 1. User Guide (printed if scanner is purchased with TMA 1000XL) 2. Using the ScanWizard Pro scanning software 3. Using the bundled third-party software To access the PDF manuals: Insert the scanner's software CD-ROM into your computer's CD-ROM drive. Next, locate and click the Manuals option when the software installer window appears on your screen. Finally, select and click the title of the manual you wish to view. Scanning Damaged Photos (using DIGITAL ICE) 1. If using the scanner without TMA: Follow steps 1 to 7 of the procedures detailed in Scanning Non-Damaged Photos (the column to the left). If the TMA 1000XL is installed: Put the Black Plate on top of the photo to cover it, with the side that reads "This side up" facing up" as described in the , "Using the TMA 1000XL section of this Guide. [. . . ] Add/Remove Hardware Wizard appears on your screen. Click the "Cancel" button and close the Control Panel. Disconnect the USB or FireWire cable from the back of your computer, and refer to the installation instructions in this guide. Energy Star Notice As an ENERGY STAR Partner, Microtek International, Inc. has determined that this scanner meets the ENERGY STAR guidelines for energy efficiency. Copyright © 2005 Microtek Lab, Inc. [. . . ]