User manual MICROTEK GNC M 515C PN0232

[. . . ] USER'S MANUAL FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. [. . . ] Plug the female end of the power cord into the AC adapter. Connect the male end of the power cord into a wall socket. Turn on your computer, and then turn on your LCD monitor. VGA Cable: Connect with VGA cable. Power: Plug into the AC power adapter. AC/DC Adapter VGA cable Power cord Note: For added protection, the use of a Surge Protection device is recommended. The Surge Protection device should be installed between the AC Adapter and the electrical wall outlet to prevent the effects of sudden current variations from reaching and damaging the LCD monitor. 5 Operating the Monitor The LCD monitor has been preset at the factory with the Timing shown in the section "Appendix B" to achieve optimal display. You can adjust the display to the desired brightness and sharpness by following the instructions. Buttons EXIT Functions Exit the OSD (On-Screen Display). -- Adjust setting bars (i. e. , CONTRAST, BRIGHTNESS, etc. ) to decrease setting values of the OSD. Adjust setting bars ( i. e. , CONTRAST, BRIGHTNESS, etc. ) to increase setting values of the OSD. Green ­ Normal operation Amber ­ Power Management (i. e. , DPMS mode: reduces power consumption < 5W when receiving no horizontal and/or vertical sync signal) + Power LED light status display How to Use the OSD (On-Screen Display) The OSD (On-Screen Display) lets you easily adjust the various settings for your LCD Monitor to desired levels of performance. The OSD includes a main menu and various submenus. Operating Procedure The buttons on the upper left side of the Control Panel are used to navigate the OSD. Follow the sequence below to do the following: navigate the OSD menu item, go through the submenus, select a setting, save or cancel the setting, and finally exit the OSD item. 1. Press " " or " " to display the OSD menu. Press " " to select the main menu item. Press " " to select the submenu item. Press "+" and "--" buttons to adjust. Press the EXIT button when finished adjusting. 6 Adjusting Monitor Display There are two ways to adjust the monitor screen: auto adjustment and manual adjustment Auto Adjustment 1. Make sure that your LCD monitor is not "CONTROLLOCKED" by pressing " " and "--" simultaneously. The "CONTROL LOCK" screen will disappear automatically or you may press "EXIT" to exit from the screen. Press either the " " or " " to display the OSD screen. Select "AUTO SETUP" of OSD screens by pressing the" " button for to "AUTO SETUP" . Press the "+" button while displaying the "AUTO SETUP" screen. [. . . ] If the cables are damaged, they may cause fire or electric shock. STOP OPERATING THE MONITOR IMMEDIATELY WHEN YOU DETECT ANY ABNORMAL OCCURRENCE If you notice any abnormal phenomenon such as strange noises, smoke, or unusual smells, unplug the monitor and contact your dealer or the nearest service center immediately. DO NOT REMOVE THE CABINET Removing the cabinet may expose you to the danger of fire or electric shock. DO NOT PUT ANY FOREIGN OBJECT INSIDE THE MONITOR Operating the monitor with foreign objects inside may cause fire, electric shock, or damage. [. . . ]