User manual MICROTEK GNC M 729S 219-20-990420-A

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. [. . . ] The monitor also has a wall-mountable stand for added convenience. The architecture of the LCD monitor incorporates an LCD panel that produces a clear display with low radiation emission. And with its low power consumption, the monitor helps you reduce your power bill as well. Unpacking Before unpacking your LCD monitor, prepare a suitable workspace for it and the computer. Look for a stable, level and clean surface near a wall outlet. Even though the LCD monitor uses very little power, you should put it in a location which allows sufficient airflow to ensure that the LCD monitor and your computer do not overheat. Set up your LCD monitor so that the panel is not facing a window where sunlight often comes in. The glare caused by sunlight reflecting off of the LCD monitor's screen will make it difficult to use the monitor for viewing. Note: Using a computer for an extended period of time with a poor workstation set-up and incorrect working habits can cause health problems. The science of ergonomics studies the relationship between health and a suitable working environment. There is a section on ergonomics at the end of this chapter. For more information on ergonomics, contact your nearest computer bookstore, or local library. The Internet also has information on this and other subjects. 1 After unpacking your LCD monitor, make sure the following items are included in the box and are in good condition: · · · · · · LCD monitor AC/DC adapter Power cord Audio cable VGA cable User Guide If you find any item to be missing or appear to be damaged, contact your dealer immediately. Do not throw away the packing material or shipping carton in case you need to ship or store the LCD monitor in the future. 2 Identifying Components A. The LCD Monitor -- Front View Figure-1: The LCD Monitor Front View 1. Power-On Indicator This Circular LED indicator stays lit when the power is on and blinks when the LCD monitor is in power-saving mode. LCD Screen The LCD monitor screen is a 17-inch TFT 1280 x 1024 screen. LCD Monitor Control Panel Refer to the next chapter for more details. 3 B. Auto: Auto adjustment "hot key": Press the Auto button to apply monitor adjustments automatically for optimized visual settings and quality. Brightness adjust hot key " ": Press the buttons to allow you to adjust the Brightness level of the LCD monitor directly. A small "Brightness" OSD is also displayed. Volume adjust hot key " ": Press the button to adjust the Volume level of the LCD monitor directly. A small "Volume" OSD is also displayed. 4 C. The LCD Monitor -- Rear View Figure-3: LCD Monitor Rear View 1. [. . . ] PROBLEM:There is no LCD display If there is no display on the LCD, refer to the following: 1. Make sure that the power indicator on the LCD monitor is lit, that all connections are secure, and that the system is running on the correct timing. Refer to "Supported Timing" on page 12. Turn off the LCD monitor and then turn it back on again. [. . . ]