User manual MICROTEK PERFORM A BATCH SCAN IN SW 5

[. . . ] Using Advanced ScanWizard To Perform A Batch Scan 1. Open an Imaging Software Such as Ulead Photo Imapact seen below. 2. [. . . ] Notice how it only shows one red check mark under Status Column. This means that there only one scan job selected. 3 6. To Perform a Batch we need to have two or more Scan Jobs Queued. To do this click on the NEW icon at the bottom of the Scan job Queue Window as illustrated below. Notice that we now have to Red Check Marks under the Status Category. Also notice we now have the second Scan job Identified as Untitled 2. 4 7. There are now two scan jobs queued, notice in our ScanWizard 5 Advanced Control Panel Preview Window, there are also two Scan Frames. (See Illustration Below) The same rules apply for each of the scan frames. You may select each scan frame individually and set the desired settings to that scan frame. For example if want the first scan frame to have settings of 100dpi in millions of colors and 100% scaling you can do a completely different setting for the second scan frame. For example the second scan frame can be set to 1000's of shades of gray, 600dpi and 200% scaling. Scan Frame One ­ Once the user has selected the desired settings for scan frame one and then the Scan button is clicked and selected, ScanWizard 5 Advanced will begin by scanning this frame first. Immediately after scanning the first scan frame, ScanWizard 5 will begin to Scan the Second Scan frame with the selected settings for that scan frame. [. . . ] The final result will be multiple final scans in your Image editing software. These scans will then be ready for custom editing, achieving, printing, emailing etc. [. . . ]