User manual MIELE BLACK DIAMOND

[. . . ] The pilot lamp goes out when the selected temperature is reached. Roller speed The roller speed can be adjusted by the roller speed selector. A lower roller speed makes it much easier when ironing complicated articles such as shirts or articles that are to be ironed folded. [. . . ] The article will be dried slowly when passing through the rotary iron. When ironing an article with a low degree of dampness, a high speed of the iron is adequate to receive a good result. Dampening an item with a spray mister will increase your result. If a Miele tumble dryer is being used, select the program marked "Machine iron". To minimize preparation time and to redampen, use warm water. Frequently Asked Questions Temperature indicator lamp How long is the heating-up time for the iron?Approximately 100 napkins. Temperature selector Heater plate + finger guard Roller Roller speed selector On-Off switch Feed board Ironing table Bar for hanging laundry Foor pedal switch 208-240V 20A Single Phase Comes with NEMA 6-20P Plug What are the three settings of the foot pedal?1) pressed down: ironing and roller moves 2) intermediate position (lift your foot slightly): just pressing, roller does not move 3) off How safe is the use of the iron?If during the ironing process you lose power, press the black heater plate release button to remove the item. Sleeves and cuffs · Smooth out the sleeve and lay it on the roller. · Iron the arm from the edge of the cuff to the armhole. · Iron both sides of the cuffs on the edge of the roller. 1. 2. Shoulder yoke/back Shirts with a shoulder yoke: · Fold the back along the yoke seam. · Lay the yoke as shown in the illustration, diagonally on the roller and then iron from the shoulder to the collar. · Remove shirt, rearrange and repeat on the other side. Back The back is ironed in two movements, from the middle back to the side seams. · Pull the shirt right side up on to the roller up to the yoke seam (or the collar seam where there is no yoke). Iron from the middle of the back to the armhole. [. . . ] Iron from the middle of the back to the armhole. The last bit under the arm is ironed with the front. · Iron the other half of the shirt as the first half but inside out. [. . . ]