User manual MIELE G 4270 SCVI

[. . . ] Operating Instructions Dishwasher G 4270 G 4275 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 07 909 170 Contents IMPORTANT SAFETY INSTRUCTIONS. 13 Items not recommended for dishwashing . 30 2 Contents Frequently asked questions . [. . . ] It can be turned off, so it does not sound at the end of a program. The buzzer for a fault cannot be turned off. ^ Turn the dishwasher off with "o". ^ Press the "Program" button and at the same time turn the dishwasher on with "g". ^ Hold the program button until the "Rinse & Hold" program indicator comes on. ^ Press the "Program" button four times. The "Intake / Drain" indicator flashes four times in intervals. The setting can be recognized by the flashing of the "SaniWash" indicator: ­ flashing: buzzer is activated ­ not lit up: buzzer is deactivated ^ To change the setting press the "Program" button for at least one second, until the "Intake / Drain" indicator lights up. ^ Turn the dishwasher off "o". 29 Additional options Default settings All settings can be reset to the factory default. ^ Turn the dishwasher off "o". ^ Press and hold the "Program" button and at the same time turn the dishwasher on "g". Hold the "Program" button until the "Rinse & Hold" program indicator comes on. ^ Press the "Program" button 12 times. The "Intake / Drain" indicator flashes once long and twice short in intervals. The setting can be recognized by the flashing of the "SaniWash" indicator: ­ flashing: all settings are factory default ­ not lit up: at least one setting was changed ^ To change the setting press the "Program" button for at least one second, until the "Intake / Drain" indicator lights up. ^ Turn the dishwasher off "o". 30 Frequently asked questions With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Problem The program does not start. Possible fault The door is not properly closed. The fuse is defective or the breaker has tripped. All program indicators are flashing fast when the door is open. Turn the dishwasher on "g" and select a program. After a few seconds: ­ Turn the dishwasher on. [. . . ] This allows for connection of the machine to either a hot (max. 140°F / 60°C) or cold water source. For lowest energy consumption and fastest possible wash times connect the dishwasher to a hot water source. All programs use hot water in the rinse cycles. [. . . ]