User manual MIELE CRYSTAL G 5175 SCVI

[. . . ] Operating Instructions Dishwasher G 5170 G 5175 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 09 016 320 Contents IMPORTANT SAFETY INSTRUCTIONS. 18 Items not recommended for dishwashing . 35 2 Contents Additional options . [. . . ] party dishware or to remove salt traces from the wash cabinet after refilling salt, not suitable for detergent tabs. To rinse dishes when a complete program is not needed. X Normal as required X X X X China & Crystal X X X X X SaniWash X X X X Express X X X X Rinse & Hold X Usage: Electrical - 0. 01 - 1. 23 kWh Water - 1. 3 - 6. 3 gal (5 - 24 l) 33 Use At the end of a program ^ Open the door slightly to check whether the program has finished. The indicator for the selected program has gone out. The program has not yet finished as long as the program indicator is still flashing. Close the door again so that the program runs to the end. Turning off At the end of a program: ^ Open the door. ^ Press the V button to turn the dishwasher off. The dishwasher continues to use electricity until turned off with the V button. To be safe, turn the water supply off if the dishwasher is unattended for an extended period of time, e. g. during vacation. In the "Express" program, the drying fan will run for a few minutes after the program is completed. You can now empty the dishwasher. Unloading the dishwasher Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. If you open the door fully after switching off, the dishes will cool much faster. Unloading the lower basket first will prevent water drops from the upper basket and cutlery tray (depending on model) from dropping onto dishes in the lower basket. tops rom steam, open the door after the end of the program either fully (never ajar) or keep it closed until you are removing all the dishes. , To avoid damage to counter 34 Use Interrupting a program A program is interrupted as soon as the door is opened. If the door is closed again, the program will continue from where it was interrupted. Changing a program If the detergent dispenser flap is already open, do not change the program. If a program has already started and you wish to change it: ^ Open the door. ^ Select the desired program with the Program selection button. ^ Start the program by closing the door. , Water in the dishwasher is hot. Only open the door if absolutely necessary and exercise extreme caution when doing so. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. 35 Additional options Buzzer A signal sounds at the end of a program and when a fault occurs. The buzzer at the end of a program sounds four times in intervals with a brief break in between. [. . . ] This allows for connection of the machine to either a hot (max. 140°F / 60°C) or cold water source. For lowest energy consumption and fastest possible wash times connect the dishwasher to a hot water source. All programs use hot water in the rinse cycles. [. . . ]