User manual MIELE CS 1011 WOK BURNER CUSTOMIZED COOKING SURFACE OPERATING AND INSTALLATION MANUAL

[. . . ] Operating and Installation Instructions Gas Combiset CS 1011 ® To prevent accidents and appliance damage, read these instructions before installation or use. ® en - US M. -Nr. 07 366 200 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. [. . . ] The stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. These cleaning products are available from Miele. Do not use stainless steel cleaner on or around the printing, it may rub off. Use only a soft sponge with some dish liquid and warm water to clean this area. 17 Cleaning and care Burner The burner can be dismantled and cleaned when cool. ^ Remove the burner parts and wash them in a solution of hot water and liquid dish soap. Make sure that the flame holes are clean and completely dry. ^ Wipe the burner base clean with a damp cloth and then dry. ^ Gently wipe the ignitor and ignition safety control with a slightly damp cloth, and then wipe dry. Make sure that no liquid gets into the appliance. Reassembling the burner ^ Place the burner head j onto the burner base m, making sure that the thermocouple k and ignitor l align through the holes in the burner head. The burner head must fit into place properly. ^ Seat the burner caps g and h into place. Be careful not to mix up the parts. 18 Frequently asked questions , Repairs should only be carries out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The burner does not ignite when the combiset is being used for the first time or after an extended period of not being used. Possible fault There could be air in the gas pipe. Solution You may need to make several attempts before the burner ignites successfully. The On/Off and residual heat indicators are flashing. Possible fault There has been a power failure. Solution Turn all the controls clockwise to "ß". You can now operate the appliance as normal. The On/Off indicator is flashing. Possible fault The gas supply has been cut-off. Solution ­ Turn all the controls clockwise to position "ß". [. . . ] Make sure that the maximum gas supply pressure before the gas pressure regulator is never more than ½ psi for both natural gas or LP gas. The minimum supply pressure to get the required gas input is 4" w. c. for LP gas. 41 Gas connection Gas pressure regulator A pressure regulator that is convertible from natural to LP gas (Propane) or vice versa is included with the appliance. The included regulator corresponds with the gas type of the combiset. [. . . ]