User manual MIELE CS 1012 DOUBLE GAS BURNER CUSTOMIZED COOKING SURFACE OPERATING AND INSTALLATION MANUAL

[. . . ] Operating and Installation Instructions Gas Combiset CS 1012 ® To prevent accidents and appliance damage, read these instructions before installation or use. ® en - US, CA M. -Nr. 07 366 180 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. [. . . ] ^ Gently wipe the ignitor and ignition safety control with a slightly damp cloth, and then wipe dry. Make sure that no liquid gets into the appliance. Reassembling the burner ^ Place the burner head o onto the burner base r, making sure that the thermocouple p and the ignitor q align through the holes in the burner head. The burner head must fit into place properly. ^ Place the burner cap n evenly onto the burner head o. Once the burner cap is in the right position, it will not move. Be careful not to mix up the parts. 17 Frequently asked questions , Repairs should only be carries out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The burner does not ignite when the combiset is being used for the first time or after an extended period of not being used. Possible fault There could be air in the gas pipe. Solution You may need to make several attempts before the burner ignites successfully. The On/Off and residual heat indicators are flashing. Possible fault There has been a power failure. Solution Turn all the controls clockwise to "ß". You can now operate the appliance as normal. The On/Off indicator is flashing. Possible fault The gas supply has been cut-off. Solution ­ Turn all the controls clockwise to position "ß". You can now operate the appliance as normal. ­ If the problem persists, disconnect the appliance from the electrical supply for a few seconds. 18 Frequently asked questions The burner does not ignite after several attempts. Possible fault Solution Disconnect the appliance from the electrical supply for a few seconds. If the problem persists, check if: ­ The burner is assembled incorrectly. ­ Reassemble the burner as shown in "Cleaning and Care - Burners". See "Cleaning ­ The burner is wet and soiled. ­ The flame slits are dry and unblocked The flame goes out after being lit. [. . . ] Make sure that the maximum gas supply pressure before the gas pressure regulator is never more than ½ psi for both natural gas or LP gas. The minimum supply pressure to get the required gas input is 4" w. c. for LP gas. 39 Gas connection Gas pressure regulator A pressure regulator that is convertible from natural to LP gas (Propane) or vice versa is included with the appliance. The included regulator corresponds with the gas type of the combiset. [. . . ]