User manual MIELE CS 1028 WOK BURNER CUSTOMIZED COOKING SURFACE OPERATING AND INSTALLATION MANUAL

[. . . ] Operating and Installation Instructions Gas Combiset CS 1028 ® To prevent accidents and appliance damage, read these instructions before installation or use. ® en - US, CA M. -Nr. 07 369 720 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. [. . . ] Do not use stainless steel cleaner on or around the printing, it may rub off. Use only a soft sponge with some dish liquid and warm water to clean this area. 16 Cleaning and care Burner Do not clean any parts of the burner in a dishwasher. The burner can be dismantled and cleaned when cool. ^ Remove the burner parts and wash them in a solution of warm water and liquid dish soap. Make sure that the flame holes are clean and completely dry. ^ Wipe the burner base clean with a damp cloth and then dry. Gently wipe the ignitor and ignition safety control with a slightly damp cloth, and then wipe dry. ^ After cleaning dry all surfaces with a clean cloth. ^ Place cover plate c over burner base d so that the ignitor and the ignition safety control extend through their respective holes in the cover plate. The cover plate must sit evenly over the burner base. ^ Place the burner base in position above the cover plate making sure that pins e slot into their respective holes in the burner head b. Reassembling the burner 17 Frequently asked questions , Repairs should only be carries out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The manufacturer cannot be held responsible for unauthorized work. The burner does not ignite after several attempts. Possible fault The burner is not assembled correctly. Possible fault Solution Solution See "Cleaning and Care Reassembling the burner". See "Cleaning and care". During the ignition process, the flame needs to touch the ignition safety control so that it heats up. If the flames does not touch, check that: ­ The burner is seated correctly. ­ There is no soiling on the ignition safety control. Possible fault The circuit breaker has tripped. Food has deposited itself between the ignitor and the burner cap. Food has deposited on the ignition safety control. [. . . ] Make sure that the maximum gas supply pressure before the gas pressure regulator is never more than ½ psi for both natural gas or LP gas. The minimum supply pressure to get the required gas input is 4" w. c. for LP gas. 37 Gas connection Gas pressure regulator A pressure regulator that is convertible from natural to LP gas (Propane) or vice versa is included with the appliance. The included regulator corresponds with the gas type of the combiset. [. . . ]