User manual MIELE CS 1322BG BARBECUE CUSTOMIZED COOKING SURFACE OPERATING AND INSTALLATION MANUAL

[. . . ] Operating and Installation Instructions Electric Barbecue CS 1312 CS 1322 To prevent accidents and machine damage, read these instructions before installation or use. en - US M. -Nr. 07 346 950 Contents IMPORTANT SAFETY INSTRUCTIONS. 19 IMPORTANT INSTALLATION SAFETY INSTRUCTIONS . 27 Installation of multiple appliances . [. . . ] Do not use any sharp pointed objects which could damage the seal between the ceramic surface and the surrounding frame, and between the frame and the countertop. When using cleaning agents for stainless steel always follow the manufacturer's instructions on the packaging. After cleaning use a soft, dry cloth to remove any moisture. This way you will prevent the build up of limescale deposits. Grates and lava rock container After each use, clean the grates and lava rock container with warm water and liquid dish soap. Pre-soak any heavy soiling, then remove with a brush. Do not use stainless steel conditioner on the lava rock container. Heating element Grill residue can best be removed from the heating element using a scouring pad. 14 Cleaning and care Lava rocks Clean the lava rocks on a regular basis. To do so, put the rocks in a container with mild solution of warm water and liquid dish soap. Let them soak briefly, stirring occasionally. Repeat this process 2 to 3 times with fresh water. Lay the rocks on a large kitchen towel to dry. Cleaning the lava rocks removes the used layer to expose a fresh surface. The rate at which the lava rocks become worn depends on the frequency and duration of use. If the amount of lava rocks in the lava rock container has deceased by half, the container must be refilled. Water trough ^ Let the water cool to a safe temperature to prevent burns. ^ Place a container (large enough to hold all water in the trough) under the drain valve. ^ Slowly open the drain valve by turning it counterclockwise, a. ^ Once the water has drained, close the drain valve by turning it clockwise, b until the water flow stops. ^ Fill the water trough with a mild solution of liquid dish soap and warm water, and rinse it out thoroughly. Use a bottle brush to clean the drain ^ Allow the solution to drain. Do not use stainless steel conditioner on the water trough. Make sure that the underside of the appliance is always accessible for draining away the water. Remember to let the water cool before draining to prevent burns. 15 Frequently asked questions , Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. What if the appliance does not heat up after it is turned on?Possible fault The overheat protection was triggered. [. . . ] ^ Align it so that it sits in the middle, and screw it to the countertop. ^ Remove the paper from the adhesive tape underneath the protection plate(s) bc. ^ Position the protection plate(s) bc against the side(s) of the appliance and press down. ^ Attach the splash guard d to the bracket a. [. . . ]