User manual MIELE CS 1327

[. . . ] ß Do not touch any electrical switch. ß Do not use any phone in your building. ß Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. [. . . ] Never use scouring agents, pads, abrasive cleaning agents, or strong cleaners, e. g. oven sprays, stain or rust removers, these could damage the surface of the appliance. Dry your combiset thoroughly after cleaning it to prevent lime deposits. Spills containing salt or sugar should be cleaned immediately. Let the appliance cool to a safe temperature before removing the grates. ^ Clean the grates, combiset and knobs with a sponge and a mild solution of warm water and liquid dish soap. Dry the combiset and grates thoroughly after cleaning. The stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. These cleaning products are available from Miele. Do not use stainless steel cleaner on or around the printing, it may rub off. ­ Reassemble the burner as shown in "Cleaning and Care - Burners". See "Cleaning ­ The burner is wet and soiled. ­ The flame slits are dry and unblocked The flame goes out after being lit. Possible fault Solution The flames are not touching the ignition safety control. Check if: ­ The burner is assembled incorrectly. ­ Reassemble the burner as shown in "Cleaning and Care - Burners". ­ There is no soiling on the ignition ­ See "Cleaning and Care". Possible fault The burner is assembled incorrectly. Possible fault The burner is assembled incorrectly. Solution Reassemble the burner as shown in "Cleaning and Care - Burners". Solution Reassemble the burner as shown in "Cleaning and Care - Burners". 20 Frequently asked questions The igniter does not spark. [. . . ] This appliance and its individual shut off valve must be disconnected from the gas supply during any pressure testing performed in excess of ½ psi (3. 5 kPa), or isolated from the gas line by closing its individual manual shut off valve at test pressures equal to or less than ½ psi (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. Failure to correctly install these items could lead to a gas leak and subsequent explosion. The gas connection must be made in accordance with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z 223. 1/NFPA 54 for the USA or - the current Can/CGA B 149. 1 and . 2 Installation Codes for gas burning appliances for Canada. [. . . ]