User manual MIELE DA 270-4

[. . . ] Operating and installation instructions Cooker hood DA 270-4, DA 270-4 EXT DA 270-4 U DA 270-4 Alu, DA 270-4 EXT Alu DA 270-4 U Alu To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 06 748 850 Contents Caring for the environment . 25 Safety distance between hob and cooker hood. 29 Operation with DSM 400 control module . [. . . ] ­ If you use very little fat for cooking, select a longer time. ­ If you only cook occasionally we recommend that you still select a short time, because grease which has built up gradually over a long period of time will harden on the grease filters and make cleaning more difficult. ^ Press the On/Off control to switch the fan off. ^ Confirm the selection by pressing the grease filter control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the run-on option control and the grease filter control at the same time. The indicator lamp for the grease filter control and one of the - / + indicator lamps will flash. 16 Operation Activating and altering the operating hours counter for the charcoal filter (. . . U models only) The charcoal filter is needed for recirculation mode. On delivery, the operating hours counter for the charcoal filter is deactivated. For recirculation mode, the operating hours counter needs to be set to suit the type of cooking you do: ^ Confirm the selection by pressing the charcoal filter control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Use the - /+ controls to select the desired time. ^ Press the On/Off control to switch the fan off. Resetting the operating hours counter for the charcoal filter ^ Press the run-on option and the charcoal filter controls at the same time. The indicator lamp for the charcoal filter control and one of the lamps above the - / + controls will flash. The indicator lamp for the charcoal filter control will light up after the cooker hood has operated for the number of hours set. The charcoal filter must then be replaced with a new one. Afterwards, the charcoal filter operating hours counter must be reset. The - /+ control lamps show the time which has been set: 1st lamp from the left = 120 hours 2nd lamp from the left = 180 hours 3rd lamp from the left = 240 hours 4th lamp from the left = deactivated ^ Press and hold the charcoal filter control for about 3 seconds while the fan is switched on. The indicator lamp for the control will go out. 17 Operation Reading the operating hours counter for the charcoal filter To check the percentage of time set already used: ^ Press the On/Off control to switch the fan on. ^ Press and hold the charcoal filter control. One or more of the indicator lamps for the - /+ controls will flash. The number of flashing lamps shows the percentage of the operating time which has already been used up. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 18 Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: - it is switched off at the isolator, or - the fuse from the fused spur connection unit is withdrawn, or - the mains fuse is disconnected, or - the screw-out fuse is removed (in countries where this is applicable). E-Cloth ^ A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. Do not use: ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents e. g. powder cleaners or cream cleaners, and abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. [. . . ] single phase 240 V, 50 Hz supply. The wires in the mains lead are coloured in accordance with the following code: Green/yellow = earth Blue = neutral Brown = live WARNING: THIS APPLIANCE MUST BE EARTHED 29 Operation with DSM 400 control module The Miele DSM 400 control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance. Once connnected, the cooker hood can only be operated when the window is sufficiently open (see also "Warning and Safety instructions"). When the window is closed, the cooker hood fan cannot be switched on. [. . . ]