User manual MIELE DA 5294 W

[. . . ] Operating and installation instructions Cooker hood DA 5294 W DA 5294 W EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 06 832 260 Contents Caring for the environment . 20 Fitting and replacing the charcoal filter . 24 Safety distance between hob and cooker hood (S) . [. . . ] On delivery, the operating hours counter for the charcoal filter is switched off, and is set at unlimited. For recirculation mode, the operating hours counter needs to be set to the required time. ^ Confirm the selection by pressing the operating hours control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. Resetting the operating hours counter for the charcoal filter ^ Press the On/Off control to switch the fan off. The indicator lamp for the operating hours control will light up blue after the cooker hood has operated for the number of hours set. The charcoal filter must then be replaced with a new one. Afterwards, the filter operating hours counter must be reset. ^ Press the + control and the operating hours control at the same time. The blue indicator lamp for the operating hours control and one of the ­ / + control lamps will flash. ^ To do this, press and hold the operating hours control for about 3 seconds while the fan is switched on. The ­ /+ control lamps show the time which has been set: 1st lamp from the left = 120 hours 2nd lamp from the left = 180 hours 3rd lamp from the left = 240 hours 4th lamp from the left = unlimited ^ Use the ­ / + controls to select the desired time. 17 The indicator lamp for the control will go out. Operation Reading the operating hours counter for the charcoal filter To check the percentage of time set already used: ^ Press the On/Off control to switch the fan on. ^ Press the operating hours control twice in succession, and hold it pressed in. The indicator lamp will light up blue. One or more of the indicator lamps for the ­ / + controls will flash. The number of flashing lamps shows the percentage of the operating time which has already been used up. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 18 Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: ­ it is switched off at the isolator, or ­ it is switched off at the wall socket and the plug removed, or ­ the fuse is withdrawn from the fused spur connection unit, or ­ the mains fuse is withdrawn, or ­ the screw-out fuse is removed (in countries where this is applicable). E-Cloth A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. ^ Wipe the surfaces dry using a soft cloth. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. Do not use: ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents, e. g. powder cleaners or cream cleaners and abrasive sponges, as well as pot scourers or sponges which have been used previously with abrasive cleaning agents. Important for appliances with stainless steel housing (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. To help prevent re-soiling, a conditioning agent for stainless steel such as Neoblank (available from the Miele UK Spare Parts Department) can also be used. [. . . ] It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance. Once connnected, the cooker hood can only be operated when the window is sufficiently open (see also "Warning and Safety instructions"). When the window is closed the cooker hood fan cannot be switched on. The indicator lamp for the On/Off touch control on the cooker hood will flash. [. . . ]