User manual MIELE DA 220-4

[. . . ] Operating and Installation Instructions Ventilation System DA 220-4 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 06 989 050 Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the appliance Operation Turning on the fan . 15 Cleaning and care Cleaning the casing . 19 After Sales Service Installation instructions Structural support Electrical data Appliance dimensions Installation Installation accessories . [. . . ] The lighting however will remain on. ^ Press the On/Off button to turn the fan back on again. 12 Operation Turning the lighting on/off The overhead lighting can be turned on and off independently from the fan. Dimming the lighting The brightness of the lighting can be adjusted. ^ While the lighting is turned on, press the light button. The lighting will dim until the button is released. ^ Press the light button briefly to turn on the lighting. ^ Press the light button briefly again to turn off the lighting. The light button indicator will go out. ^ If the button is pressed again, the lighting will brighten until the button is released. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing , Never use abrasive cleaners, scouring pads, steel wool, thinner or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. ^ Glass surfaces can be cleaned using a glass cleaner. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents, e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. 16 Cleaning and care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). The grease filters should be cleaned every 3 - 4 weeks or when the grease filter indicator lights. A dirty filter is a fire hazard. ^ To remove the grease filters pull the locking clips, 1, forward. Lower the filter 45°, 2, unhook it at the rear, 3, and take it out. Support the grease filter so that it does not fall onto the cooktop. 17 Cleaning and care Cleaning the grease filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. ^ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not blocked. [. . . ] Do not terminate the exhaust ducts in attics, garages, crawlspaces, etc. Please read and follow the "Important Safety Instructions" to reduce the risk of personal injury. Follow all local building codes when installing the hood. Exhaust ducting and connections ­ The ducting should be as short and straight as possible, and the number of sharp bends should be minimized. [. . . ]