User manual MIELE DA 251

[. . . ] Operating and installation instructions Ventilation System DA 251 DA 252-3 DA 259-3 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 802 960 Table of Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the appliance Operation Turning on the fan . 12 Reprogramming the grease filter timer . 13 Cleaning and Care Cleaning the casing . [. . . ] ^ While the lighting is turned on, press the light button. The lighting will dim until the button is released. ^ If the button is pressed again, the lighting will brighten until the button is released. If the button is pressed continuously, the light will cycle between bright and dark. ^ Press the light button again to turn off the lighting. ^ Press the On/Off button to turn the fan off. Automatic Safety Shut Off The fan will be turned off automatically 10 hours after the last button was activated. ^ Pressing the On/Off button will turn the fan back on. Turning the lighting on / off The overhead lighting can be turned on and off independently of the fan. Indirect lighting ^ Press the indirect lighting switch to "I". ^ Press the light button briefly to turn on the lighting. ^ Press the light button briefly again to turn off the lighting. The light button indicator will go out. 11 Operation Grease filter timer A timer monitors the hours of fan operation. The indicator for the grease filter will light after 30 hours of operation. The grease filters must then be cleaned. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. ^ Glass surfaces can be cleaned using glass cleaner. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. [. . . ] Read the entire installation procedure and determine height S before beginning the installation. If the hood is fitted flush to the ceiling make sure that the remaining distance to the ceiling is not greater or less than appliance height H. To fit the chimney, distance A between the top of the chimney and the ceiling must be at least 7/8" (20 mm). Cut out area in wall or ceiling for entrance of 6" (150 mm) ductwork or 5" (125 mm) ductwork with a reducing collar. 25 Appliance dimensions and Installation If the standard unit height H is not suitable to the kitchen's ceiling height, longer optional chimney extensions are available from your Miele dealer or Miele's Technical Service Department. 1140 mm - 1549 mm 26 Air extraction , WARNING Danger of toxic fumes. [. . . ]