User manual MIELE DA 251-4

[. . . ] Operating and Installation Instructions Ventilation System DA 251-4 DA 252-4 DA 259-4 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 06 712 760 Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the appliance Operation Turning on the fan . 14 Cleaning and Care Cleaning the casing . 18 After Sales Service Installation instructions Caring for the environment Installation accessories Plywood backing Electrical data Appliance dimensions and Installation Installation Installation instructions . [. . . ] Do not use a stainless steel cleaner on these controls. Cleaning the casing , Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. ^ Glass surfaces can be cleaned using glass cleaner. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents, ­ limescale removers. These will damage the surface. 16 Cleaning and Care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). ^ In a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. "Heavy Soil" or "Pots and pans". Use the recommended amount of dishwasher detergent. Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filters can be placed on a towel to air dry. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. When putting the grease filters back make sure that the locking clips are visible facing down towards the cooking surface. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ After returning the grease filters, press the grease filter button for 3 seconds to reset the timer. ^ If the grease filters are cleaned before the grease filter timer has reached its maximum, the grease filter button should be pressed for 6 seconds to reset the counter to zero. 17 The grease filters should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. A dirty filter is a fire hazard. ^ To remove the grease filters pull the locking clips, 1, forward. Lower the filter 45°, 2, unhook it at the rear, 3, and take it out. [. . . ] ^ If the hood is fitted flush to the ceiling make sure that the remaining distance to the ceiling is not greater or less than appliance height (H). If the standard unit height H is not suitable for the kitchen's ceiling height, longer optional chimney extensions are available from your Miele dealer or Miele's Technical Service Department. Standard unit H 29 1/8" - 44 7/8" (740 - 1140 mm) To fit the lower chimney section, the distance between the top of the chimney and the ceiling must be at least 7/8" (20 mm). 29 Installation Installation instructions ^ See the enclosed installation instruction sheet. ^ Please read the "Important Safety Instructions" and Installation instructions before installing this hood. Protective film The casing is covered with a protective film to prevent scratching during transport. [. . . ]