User manual MIELE DA 372

[. . . ] Operating and installation instructions Cooker hoods DA 362, DA 362 EXT DA 372, DA 372 EXT To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed or used for the first time. GiW M. -Nr. 05 889 281 Contents Caring for the environment . 13 Reading the filter operating hours counter . 13 Setting and altering the operating hours counter . [. . . ] The charcoal filters must then be replaced with new ones. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 13 Operation Setting and altering the operating hours counter You can set the operating hours counter to suit the type of cooking you do. ­ Select a short time if you roast or fry a lot. ­ If you use very little fat for cooking, select a longer time. ­ If you only cook occasionally we recommend that you still select a short time, because grease which has built up gradually over a long period of time will harden on the grease filter and make cleaning more difficult. To alter the grease filter operating hours counter The operating hours counter for the grease filter is set to 30 hours. The time set can be lengthened or shortened: you can choose 20, 30, 40 or 50 hours. ^ Use the joystick to select the time required. Press to the left for a shorter operating time, or to the right for a longer time. ^ Confirm the selection by pressing the grease filter touch control. If the procedure is not confirmed within 4 minutes of programming the steps, the cooker hood will automatically revert to the "old" data. The power level touch control lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Switch the fan on with the joystick. ^ Press the run-on option touch control and the grease filter touch control at the same time. The indicator lamp for the grease filter touch control and one of the lamps for the power level touch controls will flash. 14 Operation Setting and altering the charcoal filter operating hours counter (with recirculation mode) The charcoal filters must be fitted for the cooker hood to be used in recirculation mode. On delivery, the operating hours counter for the charcoal filters is set to unlimited. For recirculation mode, the operating hours counter needs to be set to the required time: ^ Switch the fan on with the joystick. ^ Use the joystick to select the time required. Press to the left for a shorter operating time, or to the right for a longer time. ^ Confirm the procedure by pressing the charcoal filter touch control. ^ Press the run-on option touch control and the charcoal filter touch control at the same time. The indicator lamp for the charcoal filter touch control and one of the power level touch control lamps will flash. The power level touch control lamps show the time which has been set: 1st lamp from the left = 120 hours 2nd lamp from the left = 180 hours 3rd lamp from the left = 240 hours 4th lamp from the left = unlimited All the indicator lamps will go out. If the procedure is not confirmed within 4 minutes of programming the steps, the cooker hood will automatically revert to the "old" data. 15 Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. [. . . ] where there may be great variations in temperature between the different areas, the problem of sweating or condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. Condensate trap In addition to insulating the exhaust ducting we recommend that a suitable condensate trap is also installed to collect and evaporate any condensate which may occur. When installing a condensate trap ensure that it is positioned vertically and if possible directly above the exhaust connection. 28 Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. [. . . ]