User manual MIELE DA 407

[. . . ] Operating and installation instructions Cooker hoods DA 406 DA 407 DA 409 DA 409 EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed or used for the first time. GiWOZH M. -Nr. 06 417 710 Contents Caring for the environment . 19 Fitting and replacing the charcoal filter . 24 Safety distance between hob and cooker hood (S) . [. . . ] The charcoal filter must then be replaced with a new one. After the charcoal filter has been replaced, the filter operating hours counter must be reset. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 15 Operation Filter operating hours counter You can set the operating hours counter to suit the type of cooking you do. ­ Select a short time if you roast or fry a lot. ­ If you use very little fat for cooking, select a longer time. ­ If you only cook occasionally we recommend that you still select a short time, because grease which has built up gradually over a long period of time will harden on the grease filter and make cleaning more difficult. Altering the grease filter operating hours counter The operating hours counter for the grease filters is set at 30 hours. The time set can be lengthened or shortened: you can choose 20, 30, 40 or 50 hours. ^ Confirm the selection by pressing the grease filter touch control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the On/Off touch control to switch the fan off. The indicator lamp for the grease filter touch control and one of the "­ / +" touch control lamps will flash. The "­ / +" control lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Use the "­ / +" touch controls to select the desired time. ^ Press the run-on option touch control and the grease filter touch control at the same time. 16 Operation Setting and altering the charcoal filter operating hours counter (with recirculation mode) The charcoal filter is needed for recirculation mode. The cooker hood is set at the factory for extraction mode. On delivery, the operating hours counter for the charcoal filter is set to unlimited. For recirculation mode, the operating hours counter needs to be set to the required time: The "­ / +" control lamps show the time which has been set: 1st lamp from the left = 120 hours 2nd lamp from the left = 180 hours 3rd lamp from the left = 240 hours 4th lamp from the left = unlimited ^ Use the "­ / +" touch controls to select the desired time. ^ Press the On/Off touch control to switch the fan off. ^ Confirm the selection by pressing the charcoal filter touch control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the run-on option touch control and the charcoal filter touch control at the same time. The indicator lamp for the charcoal filter touch control and one of the lamps above the "­ / +" touch controls will flash. 17 Cleaning and care Avoid: Before carrying out any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: ­ it is switched off at the wall socket and the plug withdrawn, or ­ the fuse is withdrawn from the fused spur connection unit, or ­ the mains fuse is withdrawn, or ­ the screw-out fuse is removed (in countries where this is applicable). ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents, e. g. powder cleaners or cream cleaners and abrasive sponges, as well as pot scourers or sponges which have been used previously with abrasive cleaning agents. Important for appliances with stainless steel housing (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-cloth, or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. [. . . ] The cooker hood should be installed according to local and national building regulations. Seek approval from the building inspector where necessary. ­ Where ducting is horizontal, it must be laid to slope away at at least 1 cm per metre. This is to ensure that condensate cannot drain back into the cooker hood. [. . . ]