User manual MIELE DA 424 V

[. . . ] Operating and installation instructions Cooker hoods DA 420 V, DA 420 V EXT DA 424 V, DA 424 V EXT To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed or used for the first time. GWOZHr M. -Nr. 06 740 240 Contents Caring for the environment . 20 Fitting and replacing the charcoal filter . 24 Safety distance between hob and cooker hood (S) . [. . . ] Afterwards, the filter operating hours counter must be reset. ^ Press the charcoal filter touch control for about 3 seconds. The indicator lamp for the touch control will go out. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 15 Use Filter operating hours counter You can set the operating hours counter to suit the type of cooking you do. ­ Select a short time if you roast or fry a lot. ­ If you use very little fat for cooking, select a longer time. ­ If you only cook occasionally we recommend that you still select a short time, because grease which has built up gradually over a long period of time will harden on the grease filter and make cleaning more difficult. Altering the grease filter operating hours counter The operating hours counter for the grease filter is set at 30 hours. The time set can be lengthened or shortened: you can choose 20, 30, 40 or 50 hours. The ­ /+ control lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Use the ­ /+ touch controls to select the desired time. ^ Confirm the selection by pressing the grease filter touch control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the On/Off touch control to switch the fan off. ^ Press the run-on option touch control and the grease filter touch control at the same time. The indicator lamp for the grease filter touch control and one of the ­ / + touch control lamps will flash. 16 Use Setting and altering the charcoal filter operating hours counter (with recirculation mode) The charcoal filter is needed for recirculation mode. The cooker hood is set at the factory for extraction mode. On delivery, the operating hours counter for the charcoal filter is set to unlimited. For recirculation mode, the operating hours counter needs to be set to the required time: ^ Confirm the selection by pressing the charcoal filter touch control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Use the ­ /+ touch controls to select the desired time. ^ Press the On/Off touch control to switch the fan off. ^ Press the run-on option touch control and the charcoal filter touch control at the same time. The indicator lamp for the charcoal filter touch control and one of the lamps above the ­ / + touch controls will flash. The ­ /+ control lamps show the time which has been set: 1st lamp from the left = 120 hours 2nd lamp from the left = 180 hours 3rd lamp from the left = 240 hours 4th lamp from the left = unlimited 17 Use Adjusting the height of the canopy The height adjustment feature on the canopy can be used to ­ ­ adapt the height of the hood to suit the installation conditions. ­ adjust the working area underneath the hood to the height of the user. ­ maximise vapour extraction by lowering the canopy during particularly intensive cooking. ­ create more working space above the hob by raising the canopy when required. The height of the canopy can be adjusted by up to 300 mm in air extraction mode, and by up to 250 mm in recirculation mode. ^ The canopy can be raised or lowered by touching the Up or Down controls briefly. ^ Pressing the control again stops the canopy. If it is not stopped, the canopy will automatically be raised or lowered to its fullest extent. Repeated use of the height adjustment feature over several minutes will cause it to cut out. [. . . ] ­ The exhaust ducting should be as short and straight as possible. ­ To ensure efficient air extraction, the diameter of the exhaust ducting should not be less than 150 mm. If exhaust ducting with a diameter of less than 150 mm, or if flat ducting is used, the noise level of the cooker hood will increase and extraction will be less efficient. Only reduce the diameter of the ducting if absolutely necessary, e. g. [. . . ]