User manual MIELE DA 446-4

[. . . ] Operating and installation instructions Cooker hood DA 446-4, DA 447-4, DA 447-4 EXT, DA 449-4, DA 449-4 EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 06 783 630 Contents Caring for the environment . 18 Stainless steel outer filter and grease filter . 19 Fitting and replacing the charcoal filter . [. . . ] The indicator lamp for the charcoal filter control will light up after the cooker hood has operated for the number of hours set. The charcoal filter must then be replaced with a new one. Afterwards, the filter operating hours counter must be reset. ^ Press and hold the charcoal filter control for about 3 seconds while the fan is switched on. The indicator lamp for the control will go out. The number of flashing lamps shows the percentage of the operating time which has already been used up. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 17 Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: ­ it is switched off at the wall socket and the plug removed, or ­ the fuse is withdrawn from the fused spur connection unit, or ­ the mains fuse is withdrawn, or ­ the screw-out fuse is removed (in countries where this is applicable). E-Cloth ^ A microfibre E-Cloth is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. Do not use any of the following to clean any surfaces: ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents, e. g. pot scourers, or sponges which have been previously used with abrasive cleaning agents. Please note the following advice for cleaning different surfaces. Important for appliances with stainless steel housing (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. To help prevent re-soiling, a conditioning agent for stainless steel such as Neoblank (available from the Miele UK Spare Parts Department) can also be used. Follow the manufacturer's instructions and apply sparingly with an even pressure following the direction of the grain. Housing General notes The surfaces and controls are susceptible to scratches and abrasions. Please observe the following cleaning instructions. ^ All external surfaces and controls can be cleaned using a Miele E-Cloth, or with warm water and a little washing-up liquid applied with a well wrung-out soft sponge or cloth. ^ Wipe the surfaces dry using a soft cloth. 18 Cleaning and care Important for appliances with aluminium housing: Aluminium is affected by the way that light falls on it, by the surrounding environment and by the angle you observe it from. Aluminium surfaces and controls may suffer discolouration or damage if soiling is left on for too long. [. . . ] single phase 240 V, 50 Hz supply. The wires in the mains lead are coloured in accordance with the following code: Green/yellow = earth Blue = neutral Brown = live WARNING: THIS APPLIANCE MUST BE EARTHED Operation with Control module DSM 400 The Miele DSM 400 Control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance. Once connnected, the cooker hood can only be operated when the window is sufficiently open (see also "Warning and Safety instructions"). When the window is closed the cooker hood fan cannot be switched on. [. . . ]