User manual MIELE DA 6290 D

[. . . ] Operating and Installation Instructions Ventilation System DA 6290 D To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M. -Nr. 07 852 220 Contents IMPORTANT SAFETY INSTRUCTIONS. 12 Changing the color of the glass edge lighting £ . 28 2 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. [. . . ] See the "Cleaning and care " chapter for information on cleaning filters and resetting the timer. Reprogramming the grease filter timer [ The timer may be set to suit your cooking habits. ­ If you often roast and fry foods, choose a shorter operating time. ­ If you tend to cook fat-free, choose a longer operating time. ­ If you cook only occasionally, it is better to choose a shorter operating time. This is because accumulated grease will harden over time, making cleaning difficult. The factory setting for the grease filter timer is 30 hours. You can adjust the time to 20, 30, 40 or 50 hours. ^ Press the On/Off button K to turn off the fan. ^ Press the Delayed Shut Down 5 ¢15 and filter button [ at the same time. The indicator for the grease filter [ timer and one of the power level indicators will flash. The 1 to IS indicators show the programmed time: Indicator 1 = 20 hours Indicator 2 = 30 hours Indicator 3 = 40 hours Indicator IS = 50 hours ^ Press the "­" symbol to select a shorter operating time or the "+" symbol for a longer one. ^ Store the selection by pressing the filter button [. If the procedure is not stored within 4 minutes, the hood will automatically default to the "old" data. 13 Cleaning and Care , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions". Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate the electronics and cause damage. ^ Wipe dry using a soft cloth. The following instructions for cleaning "Stainless steel" surfaces and "Stainless steel colored controls" should be followed in addition to the general "Cleaning the casing" instructions. [. . . ] ­ If flat ducting is used, the cross section must not be smaller than the cross section of the vent collar. ­ The ducting should be as short and straight as possible. ­ The exhaust ducting must not be bent or compressed. ­ Make sure all connections are secure. [. . . ]