User manual MIELE DA 249 DESIGNER WALL HOOD OPERATING MANUAL

[. . . ] Operating and Installation Instructions Ventilation System DA 249-4 To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M. -Nr. 07 781 040 Contents IMPORTANT SAFETY INSTRUCTIONS. 38 2 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. Read these instructions carefully before installing or using the Ventilation System. [. . . ] Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. 17 Cleaning and Care Grease filter The decor panel and reusable metal grease filter remove solid particles from the vented kitchen air (grease, dust, etc). The grease filter is visible when the decor cover is removed. Removing the decor cover The grease filters should be cleaned every 3 - 4 weeks, when the grease filter indicator lights, or when they are visibly dirty, whichever comes first. Always clean both the decor panel and the grease filter. ^ To remove the decor cover, pull on the release knobs. Hold the decor cover when doing this so that it does not fall on to the cooktop. Removing the grease filter , A dirty filter is a fire hazard. ^ To remove the grease filter, pull on the release knob. Hold the grease filter when doing this so that it does not fall on to the cooktop. 18 Cleaning and Care Cleaning the grease filters ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays or limescale removers. ^ In a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. In a Miele dishwasher use the "Normal" program. Use the recommended amount of dishwasher detergent. Depending on the detergent, cleaning the grease filter in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filter can be placed on a towel to air dry. ^ For cleaning the decor cover see "Cleaning the casing". ^ While the filter is removed, clean any dirt or grease from the filter casing to prevent the risk of fire. ^ If the grease filter is cleaned before the timer has reached its maximum, the grease filter button should be pressed for 6 seconds to reset the counter to zero. Inserting the grease filter ^ Angle the grease filter into position toward the front of the hood. ^ Once the front edge of the filter is in place, push up the rear of the filter so that both sides click into place. [. . . ] ­ Where the ductwork is horizontal, it must slope away from the hood at least 1/8" per foot (1 cm per meter) to prevent condensation dripping into the appliance. ­ If the exhaust is ducted through an outside wall, a Telescopic Wall Vent can be used. 35 Air extraction Condensate trap optional accessory ­ If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent flue. [. . . ]