User manual MIELE DA424V

[. . . ] Operating and Installation Instructions Ventilation System DA 424 V To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M. -Nr. 07 837 970 Contents IMPORTANT SAFETY INSTRUCTIONS. 33 2 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. Read these instructions carefully before installing or using the Ventilation System. [. . . ] While the canopy is in motion refrain from using the cooktop until the hood is at the desired position. The canopy is adjustable, allowing you to: ­ adjust the height of the exhaust hood to the installation space. ­ adjust the working space under the exhaust hood to the height of the user. ­ better remove intense cooking vapors by lowering the canopy. ­ have more cooktop working space by raising the canopy. The height can be adjusted in a range of 11 13/16" (300 mm). Continuously moving the canopy for more than a few minutes at a time will overheat the motor. It can be used again after a short pause. ^ To raise or lower the canopy briefly touch the X or Y buttons. 2 seconds the canopy will begin to move up or down as selected. ^ If you press either of the buttons again, the canopy will stop moving. If you do not stop the canopy, it automatically moves to the highest or lowest position. 15 Cleaning and Care , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions". Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. They stay hot for some time after turned off. Wet cleaning the hot bulbs will cause damage. Wait a few minutes after turning them off before cleaning. , The halogen bulbs are very hot The following instructions for cleaning "Stainless steel" surfaces and "Stainless steel colored controls" should be followed in addition to the general "Cleaning the casing" instructions. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. [. . . ] Follow all local building codes when installing the hood. Exhaust ducting and connections Use smooth or flexible pipework made from approved non-flammable materials for exhaust ducting. To achieve the most efficient air extraction and quietest noise levels, consider the following: ­ The diameter of the ductwork should not be less than 6" (150 mm). ­ If flat ducting is used, the cross section must not be smaller than the cross section of the ventilation exhaust. [. . . ]