User manual MIELE EGW 4050-14

[. . . ] Operating and installation instructions EGW 4050-14 / EGW 4050-29 EGW 4060-14 / EGW 4060-29 To avoid the risk of accidents or damage to the appliance it is essential to read these operating instructions before it is installed and used for the first time. GHirZ M. -Nr. 06 155 950 2 Contents Description of the appliance . 9 Cleaning and heating up for the first time . 14 Appliance front, control panel and interior . [. . . ] ^ Close the drawer gently: if you use too much force, it can spring open again. ^ Switch the appliance off (k) before removing the heated crockery. The temperature dial must only be turned in a clockwise direction as far as it will go and then back again. Do not turn it too far as this will damage it. When the temperature is reached, the heating element switches itself off. When the temperature falls below that selected, the heating element switches on again automatically. The temperature scale around the dial is shown in symbols rather than in °C. The symbols represent the most suitable temperature for the type of crockery depicted: ­ b approx. Drinks poured into warmed cups do not cool down so quickly. At the same time, the cups will not get too hot to handle. 60 °C for serving dishes and plates. Food stays warm for longer if served in pre-heated dishes. ­ sharp metal tools, ­ oven sprays. Aluminium fronts Aluminium is affected by the way that light falls on it, by the surrounding environment and by the angle you observe it from. Aluminium surfaces may suffer discolouration or damage if soiling is left on them for too long. The appliance front is susceptible to scratches and abrasions. Do not use: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents, e. g. powder cleaners and cream cleaners, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents, ­ stainless steel cleaning agents, ­ cleaning agents containing descaling agents, ­ dishwasher cleaner, ­ oven sprays. Appliance front, control panel and interior Allow the appliance to cool down to a safe temperature before cleaning. ^ All surfaces and controls should be cleaned using a Miele E-Cloth or with warm water and a little washing up liquid applied with a soft sponge or cloth. ^ Wipe the surfaces dry using a soft cloth. To prevent the risk of scratches and damage to the surface structure, pay particular attention to the following cleaning instructions for glass or metal fronted appliances. [. . . ] ^ Build in the combination appliance in accordance with its operating and installation instructions. 23 Installation Aligning the front of the plate warmer After building in the combination appliance, it may be necessary under certain circumstances to ­ align the front of the plate warmer ­ align the gap between the plate warmer and the combination appliance. To help you do this, there are adjusting points underneath the nuts which secure the drawer to the telescopic runners. ^ Loosen the nuts and take the plate warmer drawer out. Use the adjusters to ­ raise or lower the drawer ­ align the front of the drawer. 24 Installation Electrical connection All electrical work should be carried out by a suitably qualified and competent person, in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous. [. . . ]