User manual MIELE G 2020

[. . . ] Operating instructions Advanta Series G 2020 To prevent accidents and machine damage read these instructions before installation or use. UV M. -Nr. 06 696 000 Contents IMPORTANT SAFETY INSTRUCTIONS . 14 Items not recommended for dishwashing . 30 General problems with the dishwasher . [. . . ] Hold the "Start/Stop" button until the "Start/Stop" indicator lights. ^ Turn the program selector to the 11-o'clock position. The "Rinse" indicator does not light. ^ Press the "Start/Stop" button. The "Rinse" indicator flashes once in intervals. ^ Turn the program selector to the 9-o'clock position. The "Rinse" indicator shows if a setting was changed. ­ The "Rinse" indicator flashes: All settings are default settings. ­ The "Rinse" indicator is off: At least one setting was changed. ^ To reset the dishwasher to the default settings, press the "Start/Stop" button. ^ Turn the dishwasher off s. 28 Frequently asked questions With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Issue Possible fault None of the indicators The machine is not light or flash. ­ Turn the program selector to the desired program. ­ Press the "Start/Stop" button. The dishwasher does The program selector not start after the does not point to a Start/Stop button was program. The dishwasher stops The fuse has tripped. during a program. Reset the circuit breaker. The "Rinse", "Drying" There may be a technical ­ Turn the dishwasher off s. After a few seconds: flash at the same ­ Turn the dishwasher on. ­ Turn the program selector to the desired program. ­ Press the "Start/Stop" button. If the problem persists, call Technical Service. The drain pump runs The waterproof system when the door is has activated. [. . . ] If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 49 Plumbing Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. For lowest energy consumption connect the dishwasher to a cold water source. For fastest possible wash times, with slightly higher energy consumption, connect the dishwasher to a hot water source. [. . . ]