User manual MIELE G 2830 SCI

[. . . ] Operating instructions LaPerla G 2830 SCi To prevent accidents and machine damage read these instructions before installation or use. UV M. -Nr. 06 696 130 Contents IMPORTANT SAFETY INSTRUCTIONS . 19 Items not recommended for dishwashing . 38 2 Contents Additional options . [. . . ] See "Filling the salt container" and "Rinse aid". The rinse aid refill message is activated. Gel When using gel detergent, salt and rinse aid should be added for best results. See "Filling the salt container" and "Rinse aid". The rinse aid refill message is activated. 2 in 1 tabs The function "2 in 1" adjusts the program cycle to the use of "2 in 1" detergent products (detergent with rinse aid). The rinse aid dosage and the rinse aid refill message are deactivated. The cleaning and drying performance of these detergent products vary. 3 in 1 tabs The function "3 in 1" adjusts the program cycle to the use of "3 in 1" detergent products (detergent with rinse aid and water softener salt). The rinse aid dosage and rinse aid refill messages are deactivated. The salt usage for the water softener will be reduced to 1/3 and 1/4. Do not use this extra feature ­ when using "2 in 1" detergents (detergent with rinse aid). ­ if your tab water has a water hardness of over 21°dH (21 gr/gal [US]). See also the information from the detergent manufacturer. The detergent selection is set by default to powder detergent. ^ Select the detergent used and confirm with OK. 43 Settings J Water hardness The dishwasher is equipped with a sensor softener, which automatically detects the hardness of your tap water. After plumbing the dishwasher and finishing a program, e. g. "Rinse & Hold", the water hardness is displayed in the menu "Water hardness". ^ Touch OK to go back to "Settings J". Rinse aid For best results, the rinse aid dosage can be adjusted. The dosage can be set in steps from 0 to 6 ml. The dosage set by default to 3 ml of rinse aid per program. ^ Use a higher setting if spots appear on dry glassware. ^ Use a lower setting if streaking appears on dishes or glasses. [. . . ] All programs use hot water in the rinse cycles. ­ To use the "Energy Saver" program, a hot water connection of minimum 115°F / 45°C and maximum 140°F / 60°C (water intake temperature) is necessary. The higher the water intake temperature, the better the cleaning and drying results. A 5 ft (1. 5 m) flexible metal hose (pressure resistant up to 2030 psi) is available. [. . . ]