User manual MIELE G 2140

[. . . ] Operating instructions Inspira Series G 2140 Diamante G 2150 To prevent accidents and machine damage read these instructions before installation or use. UV M. -Nr. 06 696 010 Contents IMPORTANT SAFETY INSTRUCTIONS . 14 Items not recommended for dishwashing . 28 2 Contents Frequently asked questions . [. . . ] ^ Press the "Start/Stop" button and at the same time turn the dishwasher on s. Hold the "Start/Stop" button until the "Start/Stop" indicator comes on. The bottom program indicator flashes once long and twice short in intervals. The "Rinse" indicator shows if a setting was changed. ­ The "Rinse" indicator flashes: All settings are the factory default. ­ The "Rinse" indicator is off: At least one setting was changed. ^ To reset the dishwasher to the default settings, press the "Start/Stop" button. ^ Turn the dishwasher off s. 28 Frequently asked questions With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Issue The Start/Stop indicator does not flash after the dishwasher is turned on with s. The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. Possible fault The machine is not plugged in. Solution Insert the plug. The drain pump is running when the door is open. Reset the circuit breaker. There may be a technical ­ Turn the dishwasher off fault. After a few seconds: ­ Turn the dishwasher on. ­ Select the desired program with the program selector button. ­ Press the "Start/Stop" button. If the problem persists, call Technical Service. ­ Turn off the water The waterproof system has activated. ­ Call Miele Technical Service. 29 Frequently asked questions Problems water intake/drain Issue The "Intake/Drain" indicator flashes and lights alternately. The "Intake/Drain" indicator flashes. Possible fault The water supply is closed. Solution Open the water supply all the way. Before fixing the fault: ­ Turn the dishwasher off s. [. . . ] If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 49 Plumbing Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. For lowest energy consumption connect the dishwasher to a cold water source. For fastest possible wash times, with slightly higher energy consumption, connect the dishwasher to a hot water source. [. . . ]