User manual MIELE G 2142 PREFINISHED, FULLSIZE DISHWASHER OPERATING AND INSTALLATION MANUAL

[. . . ] Operating Instructions Dishwasher G 2142 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 07 724 040 Contents IMPORTANT SAFETY INSTRUCTIONS. 14 Items not recommended for dishwashing . 28 Preparing your appliance for an extended vacaion . [. . . ] Hold the "Start/Stop" button until the "Start/Stop" indicator comes on. ^ Press the "Program" button 12 times. The bottom program indicator flashes once long and twice short in intervals. The "Rinse" indicator shows if a setting was changed. ­ The "Rinse" indicator flashes: All settings are the factory default. ­ The "Rinse" indicator is off: At least one setting was changed. ^ To reset the dishwasher to the default settings, press the "Start/Stop" button. ^ Turn the dishwasher off "s". 29 Frequently asked questions With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Issue The Start / Stop indicator does not flash after the dishwasher is turned on with "s". The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. Possible fault The machine is not plugged in. See data plate for minimum amperage. The fuse has tripped. The drain pump is running when the door is open. There may be a technical ­ Turn the dishwasher off fault. After a few seconds: ­ Turn the dishwasher on "s". ­ Select the desired program with the "Program" button. ­ Press the "Start / Stop" button. If the problem persists, contact Technical Service. ­ Turn off the water The waterproof system has activated. ­ Contact Miele Technical Service. 30 Frequently asked questions Problems water Intake / Drain Issue The "Intake / Drain" indicator flashes. The "Intake / Drain" indicator flashes. Possible fault The water supply is closed. Solution Open the water supply all the way. Before fixing the fault: ­ Turn the dishwasher off "s". [. . . ] This can be directly connected to a water supply with 3/4" MHT (male hose thread ends). ­ Water pressure: Must be between 4. 5 - 145 psi (0. 3 - 10 bar). , To prevent damage to the dishwasher, it must only be connected to a fully vented drainage system. Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. For lowest energy consumption connect the dishwasher to a cold water source. [. . . ]