User manual MIELE G 2143SC PREFINISHED, FULLSIZE DISHWASHER OPERATING AND INSTALLATION MANUAL

[. . . ] Operating Instructions Dishwasher G 2143 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 07 724 060 Contents IMPORTANT SAFETY INSTRUCTIONS. 16 Items not recommended for dishwashing . 29 Preparing your appliance for an extended vacaion . [. . . ] If the door is closed, the program will continue from where it was interrupted. Changing a program If the detergent flap is already open, do not change the program. If a program has already started and you wish to change it: ^ Press and hold the "Start / Stop" button for at least one second. The program is canceled and "Start / Stop" flashes in the display. ^ Select the desired program and start as usual. , Open the door with care. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. 30 Additional options Turbo The "Turbo" function can be used to reduce the program run-times, in programs in which the option is available. The "Start / Stop" indicator flashes. The "Turbo" indicator lights up. The option will remain active for all programs until the setting is changed again. ^ A program can now be started as usual or the dishwasher can be turned off "K". Default settings All settings can be reset to the factory default. ^ Turn the dishwasher off "K". ^ Press and hold the "Start / Stop" button and at the same time turn the dishwasher on "K". Hold the "Start / Stop" button until the indicator lights up. ^ Press the "Delay Start" button 12 times. The "Rinse & Hold" indicator gives one long flash and two short flashes in intervals. The "Rinse" indicator lights up showing that a setting other than the factory default has been set. ­ If the "Rinse" indicator light is flashing: All settings are factory default. ­ If the "Rinse" indicator is not lit up: At least one setting has been altered from the factory defaults ^ To reset the dishwasher to the factory default settings, press the "Start / Stop" button. ^ Turn the dishwasher off "K". 31 Additional options Delay Start The starting time of a program can be delayed. The start time can be delayed from 30 minutes to 24 hours. With a delay start time between 30 minutes and 9 hours 30 minutes the delay is set in 30 minute increments. [. . . ] This can be directly connected to a water supply with 3/4" MHT (male hose thread ends). ­ Water pressure: Must be between 4. 5 - 145 psi (0. 3 - 10 bar). , To prevent damage to the dishwasher, it must only be connected to a fully vented drainage system. Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. For lowest energy consumption connect the dishwasher to a cold water source. [. . . ]