User manual MIELE G 2180SCVI FULLY-INTEG RATED, FULLSIZE DISHWASHER OPERATING MANUAL

[. . . ] Operating Instructions Advanta Series G 2170 Inspira Series G 1180 G 2180 To prevent accidents and machine damage read these instructions before installation or use. en - US, CA M. -Nr. 06 696 040 Contents IMPORTANT SAFETY INSTRUCTIONS. 14 Items not recommended for dishwashing . 28 2 Contents Frequently asked questions . [. . . ] Hold the program button until the lower right program indicator comes on. The "Intake/Drain" indicator flashes once long and twice short in intervals. The upper right program indicator shows if a setting was changed. ­ The upper right program indicator flashes: All settings are the factory default. ­ The upper right program indicator is off: At least one setting was changed. ^ To change the setting, press the program button until the "Intake/Drain" indicator lights. ^ Press the program button briefly three times. ^ Turn the dishwasher off o. 29 Frequently asked questions With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Issue The program does not start. Possible fault The door is not properly closed. Make sure it is a 15 A breaker. The dishwasher stops during a program. The dishwasher is not turned on. The fuse has tripped. 30 Frequently asked questions Issue The buzzer sounds. All program indicators flash when the door is open. Possible fault There may be a technical fault. Solution ­ Turn the dishwasher off o. After a few seconds: ­ Turn the dishwasher on. ­ Select the desired program with the program selector button. If the problem persists, call Technical Service. ­ Call Miele Technical Service. The drain pump is The waterproof system running when the door has activated. is open. 31 Frequently asked questions Problems water intake/drain Issue Shortly after the program start the program stops. The "Intake/Drain" indicator flashes and lights alternately when the door is open. The dishwasher stops, the buzzer sounds and the "Intake/Drain" indicator flashes when the door is open. [. . . ] For fastest possible wash times, with slightly higher energy consumption, connect the dishwasher to a hot water source. All programs use hot water in the rinse cycles. ­ The inlet hose is approximately 5 ft. (1. 5m) extension hose is available from the Technical Service Parts Department at the phone number listed on the back of this manual. [. . . ]