User manual MIELE G 2182SCVI FULLY-INTEG RATED, FULLSIZE DISHWASHER OPERATING AND INSTALLATION MANUAL

[. . . ] Operating Instructions Dishwasher G 1182 G 2182 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 07 724 140 Contents IMPORTANT SAFETY INSTRUCTIONS. 13 Items not recommended for dishwashing . 26 Preparing your appliance for an extended vacaion . [. . . ] The buzzer for a fault sounds continuously for up to two minutes. It can be turned off, so it does not sound at the end of a program. The buzzer for a fault cannot be turned off. ^ Turn the dishwasher off with "o". ^ Press the "Program" button and at the same time turn the dishwasher on with "g". ^ Hold the program button until the "Rinse & Hold" program indicator comes on. ^ Press the "Program" button four times. The "Intake / Drain" indicator flashes four times in intervals. The setting can be recognized by the flashing of the "SaniWash" indicator: ­ flashing: buzzer is activated ­ not lit up: buzzer is deactivated ^ To change the setting press the "Program" button for at least one second, until the "Intake / Drain" indicator lights up. ^ Turn the dishwasher off "o". 27 Additional options Default settings All settings can be reset to the factory default. ^ Turn the dishwasher off "o". ^ Press and hold the "Program" button and at the same time turn the dishwasher on "g". Hold the "Program" button until the "Rinse & Hold" program indicator comes on. ^ Press the "Program" button 12 times. The "Intake / Drain" indicator flashes once long and twice short in intervals. The setting can be recognized by the flashing of the "SaniWash" indicator: ­ flashing: all settings are factory default ­ not lit up: at least one setting was changed ^ To change the setting press the "Program" button for at least one second, until the "Intake / Drain" indicator lights up. ^ Turn the dishwasher off "o". 28 Frequently asked questions With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Problem The program does not start. Possible fault The door is not properly closed. The fuse is defective or the breaker has tripped. All program indicators are flashing fast when the door is open. Turn the dishwasher on "g" and select a program. [. . . ] This can be directly connected to a water supply with 3/4" MHT (male hose thread ends). ­ Water pressure: Must be between 4. 5 - 145 psi (0. 3 - 10 bar). , To prevent damage to the dishwasher, it must only be connected to a fully vented drainage system. Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. For lowest energy consumption connect the dishwasher to a cold water source. [. . . ]