User manual MIELE G 2432SC PREFINISHED, FULLSIZE DISHWASHER OPERATING AND INSTALLATION MANUAL

[. . . ] Operating Instructions Dishwasher G 2432 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 07 724 080 Contents IMPORTANT SAFETY INSTRUCTIONS. 16 Items not recommended for dishwashing . 30 Preparing your appliance for an extended vacaion . [. . . ] ^ Press the "Options" button until the desired function lights up. The option will remain active for all programs until the setting is changed again. ^ A program can now be started as usual or the dishwasher can be turned off "K". Tab To achieve the best results, the dishwasher can be programmed for the type of detergent being used. The "Options" button can be used to select between normal detergents (powder or gel) and tabs. The program sequence is adapted to the selected detergent type. Depending on the program selected the run-time may be extended considerably. If the "Tab" indicator is not lit, the dishwasher is set for normal detergent. If the "Tab" indicator is lit than the program sequence is adapted to suit detergents than contain rinse aid (as well as other components where applicable). The rinse aid dispenser and indicator light are deactivated. Follow the instructions of the detergent manufacturer. The cleaning and drying performance of normal detergents versus tabs varies greatly. Turbo The "Turbo" function can be used to reduce the program run-times, in programs in which the option is available. Using the "Turbo" option during the "Express" program will rinse the dishes without heat, e. g. to avoid smells, if a complete program is not yet needed. 32 Additional options Delay Start The starting time of a program can be delayed. The start time can be delayed from 30 minutes to 24 hours. With a delay start time between 30 minutes and 9 hours 30 minutes the delay is set in 30 minute increments. For 10 hours or more it is set in one hour increments. When using the "Delay Start" function, make sure that the detergent compartment is dry before adding detergent. Otherwise the detergent could stick together and not completely rinse out. Gel detergent should not be used when selecting "Delay Start", the detergent could leak out of the compartment. The "Start/Stop" indicator flashes. ^ Select the desired program with the "Program" button. ^ Press the "Delay Start" button. [. . . ] This can be directly connected to a water supply with 3/4" MHT (male hose thread ends). ­ Water pressure: Must be between 4. 5 - 145 psi (0. 3 - 10 bar). , To prevent damage to the dishwasher, it must only be connected to a fully vented drainage system. Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. For lowest energy consumption connect the dishwasher to a cold water source. [. . . ]