User manual MIELE G 450 DISHWASHER OPERATING MANUAL

[. . . ] 32 General problems with the dishwasher . 42 Cleaning the door and the door seal . 46 Cleaning the drain pump and non-return valve . 53 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Electrical Safety ~ Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. [. . . ] The buzzer for a fault cannot be set to off. ^ Press the program button and at the same time turn the dishwasher on g. Hold the program button until the lower right program indicator comes on. ^ Press the program button briefly four times. The "Intake/Drain" indicator flashes 4 times in intervals. The upper right program indicator shows if the program end buzzer is turned on or off. ­ Upper right program indicator flashes: Buzzer is turned on ­ Upper right program indicator is off: Buzzer is turned off ^ To change the setting, press the program button until the "Intake/Drain" indicator lights. ^ Press the program button briefly three times. ^ Turn the dishwasher off o. 28 Additional functions Factory default All settings can be reset to the factory default. ^ Press the program button and at the same time turn the dishwasher on g. Hold the program button until the lower right program indicator comes on. Solution ­ Open the water supply all the way. Before fixing the fault: ­ Turn the dishwasher off o. ­ Open the water supply all the way. ­ Clean the water intake filter, see "User Maintenance Instructions". ­ The water pressure at the water connection is lower than 4. 35 psi. ­ Clean the drain pump and the non-return valve. See "User Maintenance Instructions" for more info on the above. ­ Remove any kinks in the drain hose. Fault in the water drain. There may be water in the wash cabinet. 32 Frequently asked questions General problems with the dishwasher Issue Detergent is left in the dispenser at the end of a program. The detergent lid cannot be closed properly. The door and the interior walls are still wet after a program has finished. Water remains in the wash cabinet at the end of a program. [. . . ] Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 51 Plumbing Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot or cold water source. For lowest energy consumption connect the dishwasher to a cold water source. [. . . ]