User manual MIELE G 450

[. . . ] The model numbers quoted refer only to the basic model number, e. g. the G 641 SCi is described as the G 641 in this booklet. It is essential to read the Warning and Safety Instructions in the Operating Instruction booklet before installing the dishwasher. 2 Contents Installing a freestanding dishwasher . 4 Installing integrated "i" Dishwashers . Fitting protective cover plate to worktop . [. . . ] To prevent damaging surrounding fittings (e. worktops with wood edging) the fan running time can be increased by 14 minutes (see the Operating Instruction manual for the dishwasher). 21 Installing built-under "U" model dishwashers Building in dimensions: Dishwasher models G 636 - G 698 G 450 Dishwasher models G 836 - G 898 1) Niche height 890 mm 2) Niche height 840 mm 1) Niche height 870 mm 2) Niche height 820 mm Adjustment range approx. Extended machine feet are available at extra cost, (special accessory) if you wish to increase the machine height to between 89 and 94 cm. Adjustment range approx. Extended machine feet are available at extra cost, (special accessory) if you wish to increase the machine height to between 87 and 92 cm. 22 Installing built-under "U" model dishwashers 1. Fitting protective cover plate to worktop The underside of the worktop is protected against steam rising from the machine by a special cover plate. , If two different materials meet up at the front edge of the worktop, then the join must be concealed by the cover plate. ^ Remove the protective backing from the cover plate. ^ Use the tacks supplied to nail the cover plate to the underside of the worktop. Worktops with wood or laminate edging: ^ Nail the tacks through the holes which are further back from the edge. ^ Use soapy water to wipe off any excess sealant. ^ Squeeze sealant from the tube supplied all the way along the hollow moulding in the cover plate. ^ Align the cover plate to the front edge of the worktop in the middle of the niche. 23 Installing built-under "U" model dishwashers 2. Building the dishwasher into its niche Connection to water and drainage should be sited beside and not behind the dishwasher for accessibility. Connections are usually made in the area under the sink. The decor panel supplied with the dishwasher is 604 mm high. To match the height of the panel supplied or create a new decor panel this measurement needs to be shortened by dimension X. 27 Installing built-under "U" model dishwashers Adapting the height of the decor panel supplied ^ Mark the measurement X on the left and right hand side of the decor panel and on the decor frame strips. ^ Take off and shorten the decor frame strips, the decor panel and the filler card (see Step 4). Calculating the height of a new decor panel You can substitute the decor panel supplied with the dishwasher with a panel to match your kitchen decor. The dimensions for the new panel must be as follows: Width: 587 mm Thickness: minimum 1 mm and maximum 4 mm. The filler card fitted behind the decor panel supplied with the machine is not required for new panels if they are 2 mm or more in thickness. Height: 604 mm less dimension X mm ^ Mark dimension X on the left and right hand side of the decor frame strips. ^ Take off the decor frame strips, the decor panel and the filler card, and shorten the decor frame strips, and the filler card (if used). ^ Pull the dishwasher out of its recess enough to allow easy access to the front panel fixing screws on either side of the door. ^ Loosen and remove the fixing screws and push the side decor frame strips downwards until they are free of the dishwasher outer door panel and can be removed. 4. Matching the plinth facing of a kitchen run 28 Installing built-under "U" model dishwashers ^ Bow the panel slightly, pull it out from under the control panel and take it off. [. . . ] ­ The drain hose must not be shortened. ­ Ensure that the drain hose is laid so that it is free from kinks. Venting the drainage system ^ Open the dishwasher door fully. If the site drain connection is situated lower than the guide path for the bottom basket rollers in the open door the drainage system must be vented. [. . . ]