User manual MIELE G 542 DISHWASHER OPERATING MANUAL

[. . . ] 28 2 Contents Frequently asked questions . 30 General problems with the dishwasher . 46 Cleaning the drain pump and non-return valve . 52 3 IMPORTANT SAFETY INSTRUCTIONS WARNING When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. [. . . ] Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. Changing a program If the detergent flap is already open, do not change the program. If a program has already started and you wish to change it: ^ Open the door. ^ Select the desired program with the program button. ^ Start the program by closing the door. Preparing your appliance for an extended vacaion If you elect to turn off the water to your home for an extended period of time, please note that this may not be enough to reduce the risk of a leak. To be completely safe, you must turn off the water supply to each individual appliance. This means under the sink for a dishwasher, at the laundry bib for your washer, etc. 26 Additional options Buzzer A signal sounds at the end of a program and when a fault occurs. The buzzer at the end of a program sounds five times in quick succession for up to one hour. The buzzer for a fault sounds continuously for up to two minutes. It can be turned off, so it does not sound at the end of a program. If the problem persists contact Technical Service. ­ Contact Miele Technical Service. The drain pump is running when the door is opened. The waterproof system has activated. 29 Frequently asked questions Problems with water Intake / Drain Problem Shortly after the program start the dishwasher stops running. The Intake / Drain indicator flashes when the door is open. The "Intake / Drain" indicator flashes when the door is open. Possible fault The water supply is shut off. Solution ­ Open the water supply. Before fixing the fault: ­ Turn the dishwasher off "o". ­ Open the water supply all the way. ­ Clean the water intake filter, see "User Maintenance Instructions". ­ The water pressure at the water connection is lower than 4. 35 psi. ­ Clean the drain pump and the non-return valve. See "User Maintenance Instructions" for more info on the above. [. . . ] If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 50 Plumbing Waterproof system All Miele dishwashers have a safety valve located on the incoming water line and a sealed underside with a water sensor. If a fault occurs, the water intake is stopped and the drain pump is activated. Providing the dishwasher was installed correctly by a Miele technician, the waterproof system will protect you from water damage throughout the lifetime of the machine. ­ The water inlet hose comes equipped with a 3/4" female hose thread connector. [. . . ]