User manual MIELE G 595 DISHWASHER OPERATING MANUAL

[. . . ] 38 General problems with the dishwasher . 52 Cleaning the drain pump and non-return valve . 59 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Electrical Safety Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent injury and machine damage. [. . . ] If a program has already started and you wish to change it: ^ Open the door. ^ Select the desired program with the program button. The program starts. , Open the door with care. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. 32 Additional options Detergent settings To achieve the best results, set the detergent used to your dishwasher. The "Detergent" button allows you to select the function "2 in 1" or "Gel". The program cycle sequence will be adjusted for the selected detergent. Depending on the program, the program running time may be increased. "2 in 1" The function "2 in 1" adjusts the program cycle to the use of "2 in 1" detergent products (detergent with rinse aid). The rinse aid dosage and the rinse aid refill indicator will be deactivated. The buzzer at the end of a program sounds five times in quick succession for up to one hour. The buzzer for a fault sounds in intervals up to two minutes. It can be turned off, so it does not sound at the end of a program. The buzzer for a fault cannot be turned off. ^ Turn the dishwasher off with "o". ^ Press the program button and at the same time turn the dishwasher on with "g ". ^ Hold the program button for at least 4 seconds until the lower right program indicator comes on. The "Gel" indicator flashes four times in intervals. The time display shows if the program end buzzer is turned on or off. ­ "p 1": Buzzer is turned on ­ "p 0": Buzzer is turned off ^ Press the program button to change the setting. ^ Turn the dishwasher off with "o". Default setting All settings can be reset to the factory default. [. . . ] This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. , Improper connection of the equipment grounding conductor can result in electric shock. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 57 Plumbing Connection to the water supply , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. [. . . ]