User manual MIELE G 595

[. . . ] 21 Items not suitable for dishwashers: . 24 Positioning rail (depending on model) . 30 Cutlery basket (depending on model) . 44 Cleaning the door and the door seal . [. . . ] Alternatively you can open the door fully until the crockery is cool enough to unload. Do not leave the door only partially open. Glass care indicator The green "Glass care" indicator light will come on when you select a programme that is suitable for glassware. 35 Operation Switching off At the end of a programme: ^ Open the door. ^ Switch the dishwasher off using the Off button o. The dishwasher will continue to use electricity until the Off button o is switched off. If the dishwasher is not to be used for a longer period of time, e. whilst on holiday, the stopcock should be turned off. Unloading the dishwasher Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. If you open the door fully after switching off, the dishes will cool much faster. ^ First unload the lower basket, then the upper basket and cutlery tray (depending on model). This will prevent water drops from the upper basket and cutlery tray from falling onto the dishes in the lower basket. 36 Operation Interrupting a programme A programme is interrupted as soon as the door is opened. If the door is closed again, the programme will continue from the point it was at before the door was opened. Changing a programme Important: If the detergent dispenser flap has already opened, do not change the programme. to benefit from economy rates of electricity. A delay start time of between 30 minutes and 24 hours can be selected. With a delay start time of between 30 minutes and 9 hours 30 minutes, the delay is set in 30 minute stages. For 10 hours or more it is set in one hour stages. When using the Delay start function, make sure that the compartment is dry before adding detergent. If the compartment is wet, powder detergent can become lumpy and stick to the dispenser, with the result that it is not fully dispensed. Do not use liquid detergent when selecting Delay start, as it can run into the dishwasher before it is required. ^ Switch the dishwasher on with the On button g. ^ Select the programme required using the programme selector button. The last Delay start time used will appear in the Display. The Delay start indicator light d comes on. [. . . ] When connected to a hot water supply all programme stages which would otherwise be carried out with cold water will be carried out with hot water. A 1. 5 metre long flexible metal extension hose, pressure tested to 14000 kPa/ 140 bar, is available as an optional accessory if required. ­ A stopcock with a 3/4 " male thread must be provided on site. ­ This appliance is constructed to comply with IEC/EN/DIN 61770 // VDE 0700 Section 600, and may be connected to a suitable supply without an extra non-return valve if national regulations permit. [. . . ]