User manual MIELE G 811 DISHWASHER OPERATING MANUAL

[. . . ] Operating instructions G 811 dishwasher To prevent accidents and machine damage, read the Operating Instructions before installing or using the machine. ö] M. -Nr. 05 466 840 Contents Contents Guide to the appliance . 6 INSTRUCTIONS IMPORTANTES SUR LA SÉCURITÉ . 13 Programming and setting the water hardness level . [. . . ] Generally, filling the dispenser with 1 ½ tablespoons (25 ml) of detergent is enough for a thorough cleaning. If dishes are extra dirty, or if food has dried on the dishes, a program containing a prewash cycle should be selected. Add an extra tablespoon (15 ml) of detergent to compartment I in the center of the dispenser, or place directly on the inner door panel. Dishwasher detergents contain irritant and corrosive ingredients. They can cause burns in the mouth and throat if swallowed, or inhibit breathing. Keep children away from detergent and from the dishwasher when the door is open. To prevent children from coming into contact with dishwasher detergent, do not fill the detergent dispenser until you are ready to run the dishwasher. Capacities: Compartment I (prewash) holds a maximum of 3/4 ounce (20 ml) and Compartment II (main wash) holds a maximum of 2 3/4 ounces (70 ml) when completely filled. The horizontal marks in Compartment II indicate levels of approximately 3/4, 1, and 1 1/4 ounces (20, 25 and 30 ml) respectively. ^ Press the latch on the detergent dispenser. The cover will spring open. ^ Fill the dispenser with 1 ½ tablespoons (25 ml) of powder detergent, or place a detergent tablet into compartment II. 28 Operating the dishwasher Choosing a program Program selection Choose a wash program depending on the type of dishes and the degree of soiling. In most cases the "Light Wash", "Normal" or "Sani Wash" program will give excellent results. Available programs and their applications are listed in the Program Chart. The "Top Solo" feature can be used with each of these programs. For further information on "Top Solo", see "Additional features". "Energy Saver" Program Approximately 0. 20 kWh of electricity is used during this cycle. ^ Use this program for light to normally soiled dishes. The water is not heated in this program. The dishwasher must be connected to hot water of at least 45 °C/115 °F for this program to clean well. The drying result may not match that of a program with a full drying cycle. The higher the temperature of the incoming water, the better the washing and drying results will be. ^ Opening the door of the dishwasher 2-3 inches (5-6 mm) at the end of the program will speed drying. 29 Operating the dishwasher Turning on the dishwasher ^ Check that the spray arms are not blocked. ^ Press the "On/Off" button (14). The "Start" indicator lights (18). Starting a program ^ When selecting a program, refer to the program chart of this booklet. [. . . ] ^ Carefully refit the non-return valve and secure it with the locking clamp. ^ Refit and secure the combination filter. 50 After sales service After sales service If you are unable to resolve a problem or if the appliance is under warranty, please contact your Miele Dealer or the Miele Technical Service Department. Please have the model and serial number of the appliance available. These can be found on the data plate on the upper inside edge of the dishwasher door. [. . . ]