User manual MIELE G 886 DISHWASHER OPERATING MANUAL

[. . . ] Operating instructions for G 886 dishwasher To prevent accidents and machine damage, read the Operating Instructions before installing or using the machine. ö] Contents Contents Guide to the appliance . 6 INSTRUCTIONS IMPORTANTES SUR LA SÉCURITÉ . 13 Programming and setting the water hardness level . 14 Programming and changing the water hardness level. [. . . ] The "Time Left" indicator light next to the time display (15) and the "Start" indicator (21) light up. 31 Operating the dishwasher Program sequence indicator lights (16) Once a program has been started the program sequence indicator lights (16) show which stage of a program is currently in progress. Light ring (18) The light ring illuminates when the dishwasher is turned on and goes out at the end of a program. It will come on again if the program selector is turned to "Stop" or the door is opened and then closed again. If the "Delay Start" function is activated the light ring will go out 10 minutes after you have set the delay start time. It will come on again for 10 minutes if a button on the control panel is pressed or if the program selector is moved during this delay period. Time display (15) The running time of the program selected shows in the time display (15) in hours and minutes before a program is started. During a program the time left until the end of the program is displayed. The "Time Left" indicator light next to the time display lights. The time displayed for a program may vary. This is because of the water inlet temperature at each intake and because of the load size being washed. When the dishwasher is turned on the display shows an average time for a cold water intake. Times shown in the program chart refer to normal loads and average temperatures and are for guidance only. Each time a program is run the electronic unit takes into account the new conditions and calculates the program time required. This new figure is then displayed. 32 Operating the dishwasher At the end of a program A program has finished when there are no indicator lights illuminated in the program sequence display (16) and "0" appears in the time display (15). The dishwasher can now be opened and unloaded (see "Unloading the dishwasher"). If the dishwasher is not opened the fan will continue for a few more minutes to remove any remaining moisture. This process is not part of the program time. Only open the door immediately after a program has ended if dishes or cutlery are urgently needed. Always turn the dishwasher off if another program will not be started immediately. Turning off the dishwasher At the end of a program: ^ Turn the program selector (18) to "Stop". The decimal point in the time display (15) and the light ring around the program selector light. ^ Press and release the "On/Off" button (14). The decimal point in the time display (15) and the light ring around the program selector go out. The dishwasher continues to use electricity until turned off using the "On/Off" button. If the dishwasher is not to be used for a longer period of time, e. [. . . ] Program update function - PC The "PC" indicator has the function of Program Correction (PC). This allows a technician to update the programming of the dishwasher to make use of new technological developments. For example, if a detergent that gives good wash results using only cold water were to become available, the wash programs can be modified to take advantage of this. 55 Special accessories Special accessories To make the most of your dishwasher If you would like. . . milk or baby bottles . . . to wash a large number of glasses . . . to wash long-stemmed glassware then you need. . . [. . . ]