User manual MIELE GDU 60-65 INSTALLATION

[. . . ] The (i) model dishwasher is used as a basis for this conversion to a (U) model. Front panel with Decor panel (inset), 2. Plinth facia with fixing brackets The Decor set GDU is produced as standard for kitchens with a plinth height (lower edge of kitchen unit door to floor) of: 1. To match the dishwasher decor to the colour and dimensions of your kitchen furniture another decor panel can be fitted in place of the one originally provided. [. . . ] The hole in the securing piece must line up with the oval hole in the niro steel plate. ensure that the seal on the top edge of the dishwasher fits directly against the worktop. If this is not the case, adjust the height-adjustable scre feet more, (see Step 2 in the Installation section of the Operating Instructions). This step is not carried out for dishwashers installed in a kitchen with a continuous kitchen plinth facia. ­ A maximum building-in height of the machine, with the feet fully (5 cm) extended. If these measurements are less than the maximum, the door may hit the plinth facia. On each side push the spring clips aside and push the brackets right in. Place a pencil horizontally at the front lower edge of the dishwasher door and draw a horizontal line across the plinth facia. To shorten the plinth facia: ­ Trim with the saw along this line, or better ­ cut along one of the cutting lines provided if this is close enough. Score the cutting line along the plinth facia and then break off. Screw the plinth facia on with the cutting lines towards the top, and pull out evenly to adjust to the kitchen plinth rebate. please note: The plinth facia cannot be pushed back. It must be unscrewed, so that both spring clips can be pushed to the sides and the brackets pushed in. Screw the plinth facia back on to the brackets, with the cutting line at the bottom. If the door does not open smoothly the plinth facia may need further trimming. Carefully open the dishwasher door until the rear bottom edge of the dishwasher door hits against the plinth facia. A front panel with a Decor insret, and 2. A toekick with mounting brackets The GDU Decor set is made to fit kitchen cabinets with a toekick height (lower edge of cabinet door to floor) of 2 3/4 to 4 3/4 inches (70 - 120 mm). The included decor insert can be replaced with any 1/16" (1. 5 - 2 mm) thick material (plastic laminate , melamine , veneer , etc. ) to match your cabinetry, if you so desire. Install the dishwasher as instructed in its Operations Manual, making sure to remove the adapter strip (spacer bars see illustration). [. . . ] Pull the dishwasher out from under the countertop as far as is necessary to reach the 2 locking screws located on each side of the door. Loosen the screws on each side of the door, and remove the front panel. Please note: Use masking tape along the cutting line to protect the decor insert and strips from scratches while cutting them to length. use a cutting tool suitable for the material. [. . . ]