User manual MIELE H 4010 BM

[. . . ] Operating instructions Microwave combination oven H 4010 BM, H 4020 BM To avoid the risk of accidents or damage to the appliance it is essential to read these operating instructions before it is installed or used for the first time. G M. -Nr. 06 230 140 Contents Description of the appliance . 13 Cleaning and heating up for the first time . 15 Suitable containers for microwave ovens . [. . . ] l The minute minder time remaining will show in the display. m The time of day will show in the display. g The display shows the cooking duration set or the duration remaining if the programme has started. To change ^ Call up the symbol for the setting to be changed. ^ Use the + or - button to change the setting. To check and change an entered value You can check or change values entered for a cooking programme at any time by calling up the relevant symbol. To cancel programmed cooking durations ^ Turn the function selector to "0". If there is a power cut, all data entered will be deleted. 27 Microwave When using microwave power you should always place the food / dish centrally on the glass tray and slide the tray into the first shelf level from the bottom. Placing the dish on the floor of the oven will give unsatisfactory and uneven results, as no microwaves will reach the food from below. The following power levels can be selected: 80 W, 150 W, 300 W, 450 W, 600 W, 850 W and 1000 W. ^ Turn the function selector to Microwave h. ^ Whilst triangle V is flashing, use the + button to enter the required duration in minutes:seconds (e. g. The h symbol will flash in the display to tell you to start the process. W g V h ^ Press the V button to start the process. If no other symbol is selected, the cooking duration will be visible counting down in the display. At the end of the cooking duration, a buzzer will sound and the g symbol will flash. Press any button to switch the buzzer off early. The time of day will reappear in the display. If you wait for longer than a few seconds before starting the process, the ) symbol will appear in the display and you can then set the cooking duration end time. W V The display shows a suggested power level of 1000 W. ^ Whilst triangle V is flashing, use the - button to alter the setting if you wish to select a lower power level. After 5 seconds or if the V button is pressed, the following will show in the display. W g V 28 Combination programmes Microwave mode can be combined with either Fan plus or Grill. Before starting a combination programme you must first select the microwave power level and the time for the process. W g V h Microwave + Fan plus hY ^ Turn the function selector to Microwave + Fan plus h Y The display shows a suggested power level of 300 W. You can enter a duration of up to a maximum of 2 hours. With a power level of 450 W, a maximum of 60 minutes can be entered. The h symbol will flash in the display to tell you to start the process. ^ Before starting the process, use the temperature selector to choose a temperature for the Fan plus function. [. . . ] These are given on the data plate which is located on the front of the oven cavity. Please note that telephone calls may be monitored and recorded to improve our service. 54 Electrical connection IRL, U. K. , ZA All electrical work should be carried out in strict accordance with national and local safety regulations by a suitably qualified and competent service technician approved by Miele. This appliance is supplied with a mains cable and plug for connection to a 230 - 240 V, 50 Hz single phase supply. The voltage, connected load and fuse rating (where applicable) are given on the data plate situated at the front of the oven interior. Please ensure that these match the household mains supply. [. . . ]