User manual MIELE KM 5736

[. . . ] Operating and Installation instructions Ceramic hobs with induction KM 5731 / KM 5732 / KM 5733 KM 5736 / KM 5737 / KM 5752 KM 5753 / KM 5755 / KM 5757 KM 5775 To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time. Gir M. -Nr. 06 661 920 Contents Guide to the appliance . 24 Cleaning and heating up for the first time . 32 Switching off and residual heat indicators. [. . . ] Do not touch any zone or place any heat sensitive items on a zone where the residual heat indicator is lit up. Please note that the residual heat indicators do not light up when there is a fault message, even if the cooking zones are hot. To switch off the hob: ^ Touch the ON/OFF sensor s. The residual heat indicator will appear in the display of any cooking zone which is still hot. 33 Safety features Safety lock Keep children away from the hob for their own safety. Your appliance is equipped with a safety lock to prevent the hob and the cooking zones being switched on or any settings being altered. The safety lock can be activated when the hob is switched off as well as when it is in use. If the safety lock is activated when the hob is switched off, then the hob cannot be switched on. If the safety lock is activated when the hob is in use: ­ The power levels for the cooking zones and the timer settings cannot be altered. ­ The cooking zones and hob can be switched off but once switched off cannot be switched on again. To activate the safety lock: ^ Touch the safety lock sensor $ until the relevant indicator lamp comes on. The indicator lamp will go out after a short while. The lamp will come on again to show that the safety lock has been activated, if ­ you touch the safety lock $ sensor. To deactivate the safety lock: ^ Touch the safety lock sensor $ until the indicator lamp goes out. You can alter the setting from one finger to three finger operation (see "Programming - P4") to make it harder for children to operate the appliance. Please note that the safety lock will deactivate if there is a power cut. 34 Safety features Stop and Go Your appliance has a Stop and Go feature which, when activated, reduces the power of all cooking zones that have been switched on. This allows you to leave the hob unattended for a short time without any danger of pans boiling over or burning. If you wish to use this feature, you will need to alter the factory setting (see "Programming - P5"). To activate Stop and Go: ^ Touch the $ sensor until you hear two consecutive beeps. Be careful not to continue touching the $ sensor for too long, as this will activate the safety lock. The indicator lamp for the safety lock will start to flash. The power of the cooking zone in use will be reduced to setting 1, and a 1 will appear in the corresponding cooking zone display. If automatic switch-off is programmed for a cooking zone, activating Stop and Go will interrupt the count down to the switch-off time. When Stop and Go is deactivated, the automatic switch-off programme time will continue to run without further interruption. [. . . ] ^ Fix the wooden frame a 7mm below the top edge of the worktop (see diagram). ^ Feed the hob connection cable down through the cut-out. ^ Centre the hob f in the cut-out. 7 51 52 6 1 0 50 g 02 f e a ^ Connect the hob to the mains. 13 ^ Check that the hob works. ^ Seal the remaining gap g with a silicone sealant that is heat-resistant to at least 160 °C. a Wooden frame (13 mm, to be provided on site) e Worktop f Hob g Gap Corner radius of the tiled worktop ß R4 As the ceramic glass and the worktop cut-out have a certain dimensional tolerance, gap g can vary (min. [. . . ]