User manual MIELE KM 5676

[. . . ] Operating and Installation Instructions Ceramic Cooktop KM 5676 To prevent accidents and machine damage, read the Operating Manual before installation or use. UV M. -Nr. 06 611 230 Contents IMPORTANT SAFETY INSTRUCTIONS . 20 Setting the timer to turn off a burner automatically . 41 2 IMPORTANT SAFETY INSTRUCTIONS READ THE OPERATING INSTRUCTIONS CAREFULLY BEFORE USING THE COOKTOP WARNING This appliance is only intended for residential cooking. [. . . ] Do not use abrasive cleaners or pads, as they may eventually wear off the rings. ­ For the most even and energy efficient cooking, the diameter of the pots/pans should match the diameter of the burners as closely as possible. ­ Use cookware with thick, flat, smooth bottoms. Slightly concave bottoms will also work adequately. Pans with convex bottoms will not cook well. ­ Using a lid while cooking will minimize the loss of heat and decrease the cooking time. 18 Selecting cookware Copper bottom and aluminum pans may leave a residue on the cooktop in the form of metallic lines. These lines can be removed using a non-abrasive ceramic cooktop cleaner or a shielded scraper blade. Be sure to clean the cooktop after each use. Each time this residue is allowed to melt it becomes harder to remove and may mar the appearance of the cooktop. Let the cooktop cool before cleaning. Cast iron, glass or stoneware should not be used because they have poor heat transfer and may scratch the cooktop surface. 19 Timer The cooktop has a timer which can be used to time activities in the kitchen and/or automatically turn off the burners. Both functions can be used simultaneously. A time between 1 and 99 minutes can be set. The time can be decreased or increased with the - or + touch control. To set the display back to 00 press and + at the same time. If multiple times are programmed, the time which elapses first is displayed. If this time is allocated to a burner, the respective indicator will flash. Setting the timer The timer can be set with the cooktop either on or off. The timer can be set from 1 to 99 minutes. To set the timer when the automatic turn off is programmed for one or more burners: Press the sensor m until all indicators of the programmed burners light steadily and the display shows 00. The display shows 00. ^ Touch the - or + sensor until the desired time is displayed, e. g. The set time counts down in minutes in the time display. The remaining time is displayed and can be changed at any time by pressing - or +. After the set time has elapsed the display shows 00 and a tone is heard. After a few seconds the tone stops and the 00 goes out. To end the tone touch the m sensor. 20 Timer Setting the timer to turn off a burner automatically To use this feature, a power setting must be selected for the desired burner. All burners can be programmed at the same time. [. . . ] Wooden countertop Granite countertops 38 Installation Protective bottom plate Sealing The cooktop bottom must be installed in such a way that the bottom is shielded and cannot be touched. A wooden base and front cover must be installed if: ­ no oven is installed underneath. ­ the cooktop is larger than the oven or control unit underneath. ­ the cooktop and the oven underneath are built in staggered. [. . . ]