User manual MIELE KM 5753 INDUCTION COOKTOP OPERATING AND INSTALLATION MANUAL

[. . . ] Operating and Installation Instructions Ceramic Cooktop with Induction KM 5753 KM 5758 To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M. -Nr. 06 766 201 Contents IMPORTANT SAFETY INSTRUCTIONS. 30 2 Contents Cleaning and Care . 48 3 IMPORTANT SAFETY INSTRUCTIONS READ THE OPERATING INSTRUCTIONS CAREFULLY BEFORE USING THE COOKTOP WARNING This appliance is intended for residential cooking only. [. . . ] To override a stop, briefly remove your finger from the touch control, then touch it again to continue. To re-set the display to 00, simultaneously touch - and +. When the set time has elapsed, 00 will appear in the timer display for a few seconds. At the same time an audible signal will sound for a few seconds. To turn the signal off before this, touch the m sensor. Setting the timer The timer can be used with the cooktop turned on or off. Two dashes appear in the display, and the timer indicator will flash. ^ While the indicator is flashing, touch the - or + sensor until the desired time appears in the display, e. g. The time remaining can be seen in the display and changed at any time by touching - or +. 24 Timer Automatic switch-off To use this feature, a power setting must be selected for the desired burner. All burners can be programmed at the same time. If the programmed time is greater than the maximum operating hours permitted, the cooktop will eventually switch-off automatically. See "Safety cut-out feature" for more information". Two dashes appear in the display, and the timer indicator will flash. The indicator for the timer in the display goes out, and the automatic switch-off indicator flashes. ^ If several burners are being used, touch the m sensor repeatedly until the indicator flashes next to the burner you wish to use this function for, e. g. The indicator for the burners being used will light up clockwise, starting with the front left. ^ Touch the - or + sensor until the desired time appears in the display, e. g. The time remaining can be seen in the display and changed at any time by touching - or +. If you want to set another burner to switch-off automatically, repeat the same steps. If more than one switch-off time is programmed, the shortest time remaining will show in the display, the indicator for that particular burner will flash. All the other indicators will remain lit. If you want to check the remaining time for another zone, touch the m sensor until the indicator for the desired burner flashes. 25 Timer Combi mode The timer and automatic switch-off functions can be used at the same time. If you have programmed in one or more switch-off times, and would like to use the timer as well: Touch the m sensor repeatedly until the timer indicator flashes. [. . . ] Any gap between the frame and the countertop will reduce as the cooktop is used. Installing the cooktop ^ Feed the cooktop connection cable down through the cut-out. ^ Place the cooktop centrally in the cut-out. When doing so make sure that the seal under the cooktop sits flush with the countertop on all sides. This is important to ensure an effective seal. [. . . ]