User manual MIELE S2111

[. . . ] 31 How the dustbag change indicator works . 33 Replacing one type of exhaust filter with another . Improper use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the vacuum cleaner, please read these instructions carefully before using it for the first time. [. . . ] It can also be used with the brush protruding to vacuum hard flooring. Preparing for use Attaching the suction hose (dia. 1) a Insert the hose connector into the socket on the vacuum cleaner until it clicks into position. Removing the suction hose from the cleaner b Press the release buttons at the side of the hose connector and lift the hose from the socket. Connecting the handle to the suction hose (dia. 2) ^ Fit the hose connector securely into the handle, making sure it clicks into position. Your vacuum cleaner is fitted with one of the following suction tubes, depending on model (see "Description of the appliance"). – EasyLock suction tube – Telescopic suction tube Connecting the EasyLock suction tube sections (dia. 3) ^ Take the section with the connecting piece, insert it into the other section and turn it clockwise or anti-clockwise until it clicks into position. ^ Push the connecting piece upwards until it clicks into position. 9) Please observe the flooring manufacturer's cleaning and care instructions. C Vacuum carpets and rugs with the brush retracted (press foot control %). Clean hard flooring which is not susceptible to scratching with the brush protruding (press foot control )). Clean flooring which has deep crevices or grooves with the brush protruding. For general use and also for vacuuming stairs. Warning: For safety reasons when vacuuming stairs it is best to start at the bottom of the stairs and move upwards. 10) a Pull the mains cable out to the required length (max. Warning: If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. otherwise there is a danger of overheating and damage. Rewinding the cable ^ Switch the vacuum cleaner off at the wall socket and unplug it. B Press the rewind foot control briefly. 7 + 8) The following accessories are supplied: a Dusting brush b Upholstery nozzle c Crevice nozzle d Accessories holder for the three accessories supplied There are symbols on the accessories holder to show you where to postion the accessories. [. . . ] Replacement parts are available from your Miele retailer or from Miele (see back cover for contact details). Problem solving guide The vacuum cleaner switches off automatically A temperature limiter will switch the cleaner off automatically if, for instance, large articles have blocked the suction tube or when the filter bag is full or contains too much fine dust. A heavily soiled dust compartment or exhaust filter can also be the cause of overheating. Switch the vacuum cleaner off immediately using the On/Off foot control s. [. . . ]