User manual MIELE SEB 226

[. . . ] Do not use extension cords, modify the plugs, or attempt to connect any of the accessories to a non-Miele vacuum cleaner. Doing so could damage the powerbrush or other accessories and cause personal injury. Only dry surfaces should be vacuumed with these accessories. Do not allow children to play with them, and pay close attention if they are used near children. [. . . ] The powerbrush will shut off automatically if the rollers are prevented from turning; for example if a large object has been vacuumed. Should this occur, unplug the vacuum cleaner before correcting the problem. Allow 2 - 3 minutes for this safety feature to reset itself before restarting the vacuum. use only Miele attachments and accessories. Use of non-Miele designed items will decrease the efficiency of your machine and may be dangerous. Do not attempt any repairs other than those listed in the "Maintenance and care section. Any other required service should be performed by an Authorized Miele Service Agent. Always unplug the machine before connecting or disconnecting any accessories from the vacuum cleaner. Electric Wand SET 210 The SET 210 is an electric wand that carries power to the Powerbrush through internal cabling. It can be identified by a small plug at the top rear and bottom rear of the wand. A Handle b Release button for suction wand c Height adjustment switch d Brush height indicator e Blockage warning light f Suction wand lock Canister vacuums The connection procedure will vary depending upon which vacuum, electric hose, suction wand and powerbrush model you purchased. Please find the combination of components you have on the following pages and use those instructions to connect the powerbrush to your vacuum cleaner. When vacuuming rug fringes, place the Powerbrush on the rug and pull it over the fringe onto the floor. Never push the Powerbrush over fringes, as they may become entangled in the brush roller. For suggestions and recommendations on which type of Powerbrush or floor tool will work best for your application, please contact your Miele Vacuum Dealer. SEB 217 with an upright vacuum cleaner The Powerbrush will start automatically when the vacuum cleaner is turned on. SEB 217, SEB 213 and SEB 226 The powerbrush can only be turned on if the vacuum cleaner is also on. The switch that controls the power brush can be found on the hose handle, as shown in the illustration below. ^ To achieve the best results, slowly pass the Powerbrush back and forth over the carpet. SEB 213 / SEB 217 indicator light The electrobrush warning light has a double function. It lights ­ green, when the brush is in use ­ red, if the brush roller is blocked. This can occur if enough threads wrap around it or if a large or long object has been vacuumed up. [. . . ] A new roller brush or a brush with slightly worn bristles should be installed with the single notch facing up (left illustration). If the roller brush is old and/or the bristles are worn: ^ Install the supports so that the two notches are facing up (right illustration). The correct orientation of the supports allows the proper length of bristle to protrude from the roller cover. The brush can continue to be used in the "two notch" position until the bristles wear down to the point where they no longer clean. [. . . ]