User manual MIELE T 224

[. . . ] Operating instructions for vented tumble dryer T 224 To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed and used for the first time. G M. -Nr. 06 465 680 Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children. [. . . ] Remove any fluff. The vent ducting or the ­ Check all parts of the ventilation outlet is blocked. extraction system on a regular basis (e. g. wall vent, external grille, bends in the ducting etc. ) and make sure they are all free of any hindrance. Make sure that your laundry is thoroughly spun at the appropriate spin speed. The tumble dryer has been Do not exceed the maximum overloaded. ­ Close zips and fasten any Metallic components, e. g. zips have prevented the hooks next time. dryer from registering the If the problem occurs again, correct moisture level in the dry garments with long zips laundry. using "Timed drying - Warm air". The laundry has not been spun sufficiently. 20 Problem solving guide Check and fault indicator lamps Problem The programme has stopped. The Anti-crease/Finish lamp has come on in the sequence display and the buzzer is sounding. Remedy Use the "Timed drying This is not a fault. Warm air" programme to The electronic unit has recognised that there is no dry individual items. Before changing a laundry in the drum and cancelled the programme. programme: Open and Drying individual garments close the drum door. or items which are already dry can also cause the programme to be stopped. ­ Switch the dryer off and then on again. If the programme stops again and the fault message reappears there is a fault. Possible cause The programme has been interrupted. The indicator lamp for Hand iron or Machine iron is flashing, and the buzzer sounds. 21 Problem solving guide Changing the lamp Disconnect the machine from the mains electricity supply. You will find the interior lamp cover at the top of the drum aperture. The lamp specification and maximum wattage is stated on the data plate and on the lamp cover. [. . . ] E Turn the programme selector to Minimum iron - Normal. F Pressing the Start button alters the drying level. ­ If the Drying indicator lamp is flashing: the standard drying level is Normal+ ­ If the Drying indicator lamp is not flashing, the increased drying level is not activated and the drying level will remain on the standard setting ( ). G Switch the machine off with the I-On/0-Off button. [. . . ]