User manual MIELE T 1520

[. . . ] Operating Manual for the T 1520 Vented Dryer In order to protect yourself and avoid damage to your machine, it is absolutely necessary to read the operating instructions prior to installation and operation. ] M. -Nr. 05 275 050 Contents Contents Guide to the machine. 5 Your contribution to the environment . 14 14 15 18 19 19 20 23 Consumption data . [. . . ] Items which are only to be aired. Max. load - Special instructions This setting will run the full length of time regardless if the item is dry beforehand. - cool 5 kg 13 USER MAINTENANCE INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS Cleaning and care Cleaning the lint filters The lint is collected by the lint filter in the door. Clean the filter after every program. Cleaning the dryer Before cleaning the tumble dryer; disconnect the machine from the power supply. The dryer can be cleaned using soapy water or a mild detergent (not scouring powder) and dried with a soft cloth. The drum may be cleaned using a suitable stainless steel cleaner following the manufacturer's instructions. Do not use any abrasive substances or scouring pads to clean the machine. Grip the filter by the recessed handle and pull up to remove. Any remaining lint in the hollow part of the door can be removed through the gap at the bottom. The lint filter can be rinsed with water if necessary. Dry the lint filter before putting it back in place. 14 Problem solving guide Problem solving guide Electrical appliances should only be repaired by qualified personnel. Incorrectly repaired machines may put the user at risk. There are, however, minor problems which can be corrected without contacting the Service Department. What to do if, . the tumble dryer fails to start when turned on? Cause . . Check whether the "On" indicator lights up. If so, failure to start may be due to an incorrect program selection procedure. If the "On" indicator lamp does not illuminate, check that: Remedy . . Repeat the switch-on procedure in the correct sequence, as outlined in the "Program Selection" chapter. ­ The "ON/OFF" button is depressed. ­ The machine is plugged in and the fuse or circuit breaker has not tripped. the laundry is not sufficiently dry? The load consists of dissimilar items (size and fabrics). Small loads can be time-dried. Small loads or individual items may cause the program to terminate the cycle prematurely. the "anti-crease" indicator lamp in the sequence indicator display starts flashing? [. . . ] The additional length factor is then added to the measured duct length to give the effective duct length. A larger duct diameter also helps to reduce friction. The duct diameter should therefore be increased with increasing duct length. Tabel I Type of bend Flexible metal piping Angle 90° 90° 45° 90° 90° 90° Radius in mm 100-300 300-500 100-500 100 200 200 Additional duct length in m 0. 5 0. 4 0. 4 0. 4 2. 5 0. 8 0. 6 3. 8 1. 5 Exhaust connection, left/right side Flat section adaptor 6/10 8 Measure the actual duct length. [. . . ]